Federal FCC-4 Installation & Operation Instructions

Also see for FCC-4: Installation & operation instructions

Contents

Federal FCC-4 Installation & Operation Instructions Manual pdf 7 page image

ShelvingThe case is equipped with three tiers of adjustable glass shelves. The deepest shelf is at thebottom and the shallowest at the top. Each tier is supported by three (3) shelf brackets.Turn the shelf light switch “off”.Remove both rear doors from the track by lifting them upward until the bottom edge clears thelower door track and then outward.To install the bottom shelf, put a 14” shelf bracket in the end shelf standard even with or abovethe bottom light socket and tighten the locking cam.Then install a center shelf bracket in the center shelf standard and tighten the locking cam.The center shelf bracket has no end hook and is shorter than the end brackets in order to clearthe shelf light housing.Hang the shelf light assembly with the longest cord on the end shelf brackets.Plug the shelf light cord in the light socket. Make certain the light cord is completely insertedinto the socket or arcing may result causing damage to the plug and socket.Each shelf bracket gets two plastic supports with rubber pads. Put two single width supportson each end shelf bracket. Put two double width supports on the center shelf bracket.Repeat the steps for the middle and top shelves.Put the glass shelves on the support pads as shown for each tier. If the shelf is not in theproper position, it may disrupt air flow in the case and cause product loss.Reinstall both rear doors.LightsMake certain that the light cord plugs are completely inserted into the sockets or arcing mayresult causing damage to the plugs and sockets.CleaningFor initial setup, clean the case as outlined in the Weekly Cleaning Section.