Federal SSRSP Series Installation & Operation Instructions

Federal SSRSP Series Installation & Operation Instructions Manual pdf 10 page image

- 10 -SHELVING INSTALLATION & REMOVALShelf Bracket & Supports InstallationSHELF STANDARDREAR SHELF SUPPORTSHELF BRACKETSHELF LIGHT CORDRETAINER CLIPSHELF STANDARDRETAINING SCREWREAR SHELF SUPPORTLIGHT ASSEMBLYLIGHT ASSEMBLYSHELF LIGHT CORDRETAINER CLIP1. Turn the light switch to the off position.2. Follow the instruction in the illustration below and insert (1) of the (2) shelf brackets in the desiredshelf standard slot on one side of the case. Place the additional shelf bracket at the same height on theshelf standard slot on the opposite end of case. The bracket with a shelf light cord retainer clip must beon the side with the shelf light receptacle.0v NOTCH6v NOTCH41234INSTALLATION REMOVAL2 31TOP HOOKBOTTOM TABSHELF BRACKETSHELF STANDARD1. Place shelf bracket top hook into desired shelfstandard slot.2. Lift shelf bracket top hook to allow shelf bracketbottom tab to clear shelf standard slot.3. Swing shelf bracketbottom tab into shelf standardslot.4. Place the desired shelf bracket notch of 0, 6, or 12degrees onto bottom of shelf standard slot.1. Lift shelf bracket up to allow shelf bracket notchto clear the bottom of shelf standard slot.2. Swing shelf bracket bottom tab out of shelfstandard slot.3. Drop shelf bracket down to allow shelf bracket tophook to clear top of shelf standard slot.4. remove shelf bracket top from shelf standard slot.CLEAR BUMPERTOWARDS END PANEL3. Hang one end of the shelf light housing or shelf support on the front notch of a shelf bracket. Hang theother end of the shelf light housing or shelf support on the notch of the other shelf bracket.4. Push shelf light cords into plastic shelf cord retainer clip located on inside of shelf bracket.5. Remove the cap from the appropriate female light sockets.IMPORTANT: Grip each side of cap firmly and wiggle and pull cap straight out of socket. Do not rollcap during removal. Incorrect removal of cap may cause damage to electrical connection.