Federal SSRSP Series Installation & Operation Instructions

Federal SSRSP Series Installation & Operation Instructions Manual pdf 11 page image

- 11 -RIGHT WRONG6. If the socket is not being used for a shelf light, the cap must be plugged into the socket. On models withthe 5 pin shelf plug, this is necessary for the entire light system to operate. On models with the 3 pinshelf plug, this is necessary to prevent buildup and damage to the receptacle.7. Plug in shelf light by aligning the male pins on the appropriate shelf light cord plugs with the femalelight sockets and push together. IMPORTANT: Do not roll plug during insertion.8. Hang one end of the shelf support on to the rear notch of one shelf bracket and then on the rear notch ofthe shelf bracket on the opposite side.9. Place supplied shelving onto shelf supports as outlined in the appropriate “Shelf Installation” section ofthis manual.10. Removal of shelving is performed by following steps in reverse order.11. The shelf standards are removable from case by removing the (2) shelf standard retaining screwsholding them to the inside wall of case.Solid Shelf InstallationSHELF STANDARDREAR SHELF SUPPORTSHELF BRACKETSHELF LIGHT CORDRETAINER CLIPSHELF STANDARDRETAINING SCREWREAR SHELF SUPPORTSHELF LIGHT ASSEMBLYOR SHELF SUPPORTSHELF LIGHT ASSEMBLYOR SHELF SUPPORTTABSLOT1. Install shelf brackets and shelf supports as described in the Shelf Bracket & Supports InstallationSection of this manual.2. Place the front of metal shelf onto front shelf light assembly or front shelf support. The tab on end ofshelf bracket must go through slot in front of shelf.3. Place the back of shelf over the back of the rear shelf support.