15enHand/arm vibrationsThe vibration emission level given in this informationsheet has been measured in accordance with a standard-ised test given in EN 60745 and may be used to compareone tool with another. It may be used for a preliminaryassessment of exposure.The declared vibration emission level represents themain applications of the tool. However, if the tool is usedfor different applications, with different accessories orpoorly maintained, the vibration emission may differ.This may significantly increase the exposure level overthe total working period.An estimation of the level of exposure to vibrationshould also take into account the times when the tool isswitched off or when it is running but not actually doingthe job. This may significantly reduce the exposure levelover the total working period.Identify additional safety measures to protect the opera-tor from the effects of vibration such as: maintain the tooland the accessories, keep the hands warm, organisationof work patterns.Operating Instructions.The self-start lock prevents the power tool from auto-matically restarting again, even after a brief interruptionof the power supply, e. g., from a pulled mains plug.Guide the machine with the sanding belt against the pipesubject to sanding until the pipe is covered about halfwayby the sanding belt.Always hold the machine with both hands and at a rightangle to the pipe (also applies for pipe arcs).Sand the pipe uniformly applying a continuous lengthmotion.Repair and customer service.When working metal under extreme operat-ing conditions, it is possible for conductivedust to settle in the interior of the power tool.The total insulation of the power tool can be impaired.Blow out the interior of the power tool via the ventila-tion slots frequently with dry and oil-free compressed air,and connect a residual current device (RCD) on the lineside.If the supply cord of this power tool is damaged, it mustbe replaced by a specially prepared cord available throughthe FEIN customer service centre.The current spare parts list for this power tool can befound in the Internet at www.fein.com.If required, you can change the following parts yourself:Sanding beltWarranty and liability.The warranty for the product is valid in accordance withthe legal regulations in the country where it is marketed.In addition, FEIN also provides a guarantee in accordancewith the FEIN manufacturer’s warranty declaration.The delivery scope of your power tool may include onlya part of the accessories described or shown in thisInstruction Manual.Declaration of conformity.FEIN declares itself solely responsible for this productconforming with the relevant provisions given on the lastpage of this Instruction Manual.Technical documents at: C. & E. FEIN GmbH, C-DB_IA,D-73529 Schwäbisch GmündEnvironmental protection, disposal.Packaging, worn out power tools and accessories shouldbe sorted for environmental-friendly recycling.OBJ_BUCH-0000000019-002.book Page 15 Monday, December 17, 2012 4:12 PM