GCC Technologies RX Series User Manual

Contents

GCC Technologies RX Series User Manual Manual pdf 52 page image

RX Series User ManualThe Control Panel 3-73.4 Menu ItemsBelow describes the functions of menu itemsMenu or Key Function Setting Default--- Media sizing ---Roll To measure media width. Maximum MediaLength 150MEdge To measure media width and pull the media back till the frontpaper sensor open.Maximum MediaLength 150MSingle To measure media width and length. Maximum MediaLength 10M--- POWER ---To indicate the power status.[ Arrow Keys ]1. To move the tool carriage position on X or Y axis.2. To select functions or change values of settings.[ ENTER ]1. The displayed parameters will be saved automatically.2. To set a new origin at the present tool carriage position.In “offline” mode, moving the tool carriage to desiredposition by [Arrow Keys], then press [ENTER] key to set anew origin. While moving with the parameters of XY-axesdisplayed, press [MISC] key will enable fine-tunemovement; press [MISC] key again to disable the function.[ PAUSE/RESUME ]To temporarily halt the cutting process.To resume the process by press [Pause/Resume] key again.[ ONLINE/OFFLINE ]1. To switch between online mode and offline mode.2. To stop the cutting job or abort the change of setting.Once press this key, the cutting job will be terminatedimmediately and cannot be resumed.[ OFFSET ]To set or modify the distance between the blade tip and thecenter axis. Through left or right arrow keys, users can selectthe blade used (Red, Green, Yellow, Blue, Black cappedblade or Pen) then adjust the offset values after pressingEnter if necessary0.000~1.000mm 0.275mm[ FORCE ]To set or modify the value of tool force.When the cutting force exceeds 450g, the maximum cuttingspeed would be 30cm/sec and the cutting quality would beSmall Letter Mode and while the cutting force is 300g-449g,the maximum cutting speed would be 30 cm/sec and thecutting quality would be Fine Mode.5~600gram;5 gram/per step80 gram[ SPEED ]Speed To set or modify tool speed at horizontal moving.When the cutting speed exceeds 72 cm/sec, the cuttingquality would be Normal Mode.3~153cm/sec;3cm/sec per step72cm/secUp Speed To set or modify tool speed at vertical moving. 3~153cm/sec;3cm/sec per step72cm/sec