RX Series User ManualOperation 4-84.4 How to Cut 3mm LettersTo obtain good quality output, narrow media is recommended. However, if wide media is used,you should:1. Position two pinch rollers as close as possible to both edges of the cutting area.2. Make sure the loaded media is held flat with equal tension across the platen.3. Suggested operation settings:Tool force: 55 gf. (or depending on the material)Cutting speed: 45-50 cm/secTool up speed: 45-60 cm/secSmooth cut: DisableQuality: Small Letter4.5 How to Make a Long PlotWhen you are making a long plot with a roll of heavy and wide vinyl, paper you need to use the“AUTO UNROLL MEDIA“ function. The following parameter settings are to help users get thebest cutting quality. The actual output quality may vary when using different kind of materials1. If the length of graphic is between 3m and 5m, the cutting speed isbetter slower than 72cm/sec and the cutting quality is set as Normal.2. If the length is longer than 5m or if the material type is difficult to cut, itis better to further slow down the cutting speed.3. After loading the roll media all pinch rollers are raised at this stage,flatten the media on the platen and hold the front edge of the roll mediafirmly (Figure 4-15).Figure 4-15
