GE 131-10595-2 1-07 JR Installation Instructions Manual

Also see for JDP39: Use and care guide Owner's manual Owner's manual Owner's manual Owner's manual

Contents

GE 131-10595-2 1-07 JR Installation Instructions Manual Manual pdf 1 page image

131-10595-2 1-07 JRBEFORE YOU BEGINRead these instructions carefully andcompletely.• IMPORTANT — Save theseinstructions for local inspector’s use.• IMPORTANT — Observe allgoverning codes and ordinances.• Note to Installer – Be sure to leave theseinstructions with the consumer.• Note to Consumer – Keep these instructionsfor future reference.• Proper installation is the responsibility of theinstaller and product failure due to improperinstallation is NOT covered under the warranty.• NOTE – This appliance must be properlygrounded.• ATTENTION INSTALLERAll electric drop-in ranges must be hard wired(direct wired) into an approved junction box.A plug and receptacle is NOT permitted onthese products.ElectricDrop-In RangeInstallationInstructions JDS28, JDP39MATERIALS NEEDEDJunction Box Wire NutsStrain Relief Clampfor 1/2” conduitPARTS INCLUDEDLower Trim2 Screws2 Shoulder Screws(for stop device)TOOLS YOU WILL NEED1/8” Drill Bit andElectric or Hand DrillPhillips ScrewdriverNut DriverLevelTape MeasureStraight Edgeor SquareHand or Sabre SawStandard ScrewdriverPencilSafety GlassesHammerQuestions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.com