GE 165D4700P390 Owner's Manual

Contents

8Operating Instructions Safety InstructionsConsumer Support Troubleshooting TipsEnhancementsThe light above the selected pad will be ON to indicate which ENHANCEMENT has been selected.DELAY HOURS You can delay the start of a wash cycle for up to 24 hours (depending on model).Press the DELAY HOURS pad to choose the number of hours you want to delay thestart of the cycle; then press START/RESET.The machine will count down and start automatically at the correct time.NOTE: To cancel the DELAY HOURS selection before the cycle begins, repeatedly pressthe DELAY HOURS pad until the display is blank.ADDED HEAT When selected, the cycle will run longer with heating element on to improve both washand dry performance.NOTE: Cannot be selected with RINSE ONLY cycle.STEAM For use with heavily soiled and/or dried-on, baked-on soils. This option MUST beselected PRIOR to starting the cycle. The STEAM option adds 26 minutes tothe cycle time.NOTE: Cannot be selected with RINSE ONLY cycle.HEATED DRY When HEATED DRY is off, dishes will air dry.Light OffHEATED DRY Turns the heater on for faster drying. This will extend the total cycle time betweenLight On 8 and 38 minutes depending on the cycle selected. NOTE: Cannot be selected withRINSE ONLY cycle.LOCK You can lock the controls to prevent any selections from being made. Or you can lockthe controls after you have started a cycle.Children cannot accidentally start dishwasher by touching pads with this optionselected.To unlock the dishwasher controls, press and hold the HEATED DRY pad for 3 seconds.The light above the lock pad will turn off. To lock the dishwasher, press and hold theHEATED DRY pad for 3 seconds. The light above the LOCK pad will turn on.RESET To change a cycle after washing starts…Touch the START/RESET pad to cancel the cycle. The START/RESET light will flash whilethe water is pumped out if needed. This takes approximately 2 minutes.StartClose and latch the dishwasher door and select the cycle and desired enhancements. Touch theSTART/RESET pad once to begin the cycle. Water fill begins immediately, and approximately 60 secondslater the wash action begins.When the dishwasher door is fully closed and latched, the control panel lights will display the last settingsyou selected. If you don’t want to change any of the settings, simply touch the START/RESET pad tobegin the cycle.If the door is closed, the indicator lights will turn off if the START/RESET pad is not selected within 5 minutes.To activate the display, open and close the door or press any pad.CleanThe CLEAN light will illuminate and a double beep will sound when a wash cycle is complete. The CLEANlight will turn off when the door is opened.534About the dishwasher control panel.