GE 17 Owner's Manual And Installation Instructions

Also see for TOP-FREEZER 16: Owner's manual Owner's manual Use and installation guide Use and care guide with installation instructions Owner's manual

Contents

GE 17 Owner's Manual And Installation Instructions Manual pdf 7 page image

About storage drawer and cover removal. GEAppliances.comNot all features are on all models.Twin Drawer ShelfTo remove:1 Remove the drawers.2 Reach in, push the front of glass cover up,and at the same time, pull it forward as faras it will come.Tilt it and take it out. Avoid cleaning the coldglass cover with hot water because theextreme temperature difference may cause itto break.3 Remove the drawer frame. (Always removethe glass cover before you take out thedrawer frame.)Lift the frame off the supports at each sideand back, pull it forward, tilt it and take it out.To replace:1 Lower the frame until it rests on thesupports at each side and back.2 Replace the glass cover, pushing its rearedge firmly into the rear frame channeland gently lowering the front into place.3 Replace the drawers.Drawer and Cover RemovalDrawers can be removed easily by graspingthe sides and lifting up slightly while pullingdrawers past the stop location.To remove the cover, lift it off its supports,pull it forward, tilt it and take it out.About the automatic icemaker.A newly-installed refrigerator may take 12 to 24 hours to begin making ice.Automatic Icemaker (on some models)The icemaker will produce approximately70-100 cubes in a 24-hour period, dependingon the freezer compartment temperature, roomtemperature, number of door openings and otheruse conditions.If the refrigerator is operated before the waterconnection is made to the icemaker, set the switchto OFF or move the feeler arm to the STOP (up)position.When the refrigerator has been connectedto the water supply, set the switch to the ONposition or move the feeler arm to the ON(down) position.The icemaker will fill with water when it cools to15°F. A newly-installed refrigerator may take 12 to24 hours to begin making ice cubes.Once the icemaker starts to make ice, it maytake up to 48 hours to fill the bin, depending onthe temperature settings and number of dooropenings.You will hear a buzzing sound each time theicemaker fills with water.Throw away the first few batches of ice to allowthe water line to clear.Be sure nothing interferes with the sweep of thefeeler arm.When the bin fills to the level of the feeler arm,the icemaker will stop producing ice.It is normal for several cubes to be joinedtogether.If ice is not used frequently, old ice cubes willbecome cloudy, taste stale, shrink or fusetogether.Icemaker Accessory KitIf your refrigerator did not already come equippedwith an automatic icemaker, an icemakeraccessory kit is available at extra cost.Check the back of the refrigerator forthe specific icemaker kit needed foryour model.Feeler Armin the STOP(up) positionFeeler Arm inthe ON (down)position7There are 2 types of icemakers:Power switch modelFeeler arm modelON OFFIce makerFeeler ArmPower Switch