GE 197D3351P003 Owner's Manual And Installation Instructions

Also see for 20: Owner's manual Use and care guide Use and care Owner's manual and installation instructions Owner's manual and installation instructions

Automatic Icemaker (on some models)The icemaker will produce seven cubesper cycle—approximately 100–130 cubesin a 24-hour period, depending on freezercompartment temperature, roomtemperature, number of door openingsand other use conditions.If the refrigerator is operated before thewater connection is made to the icemaker,set the power switch in theO (off) position.When the refrigerator has been connectedto the water supply, set the power switch tothel (on) position.The icemaker will fill with water when itcools to 15°F. A newly-installed refrigeratormay take 12 to 24 hours to begin makingice cubes.Throw away the first few batches of ice toallow the water line to clear.Be sure nothing interferes with the sweepof the feeler arm.It is normal for several cubes to be joinedtogether.If ice is not used frequently, old ice cubeswill become cloudy, taste stale and shrink.If ice cubes get stuck in the icemaker,thegreen power light will blink. To correct this,set the power switch toO (off) and removethe cubes. Set the power switch tol (on) torestart the icemaker. After the icemaker hasbeen turned on again, there will be a delayof about 45 minutes before the icemakerresumes operation.NOTE: In homes with lower-than-average waterpressure, you may hear the icemaker cycle multipletimes when making one batch of ice.About crisper removal.www.GEAppliances.comNot all features are on all models.Consumer SupportTroubleshooting TipsOperating InstructionsSafety InstructionsInstallation InstructionsAbout the automatic icemaker.A newly-installed refrigerator may take 12–24 hours to begin making ice.Crisper RemovalCrispers can easily be removed by tilting upslightly and pulling paststop location.If the door prevents you from taking outthe crispers, the refrigerator will need tobe rolled forward until the door opensenough to slide the crispers out. In somecases, when you roll the refrigerator out,you will need to move the refrigerator tothe left as you roll it out.When replacing the crispers, makesure you slide them through thecrisper guides.There is an upper freezer shelfabove the icemaker that can beused for storage.CrisperGuidesIce Storage DrawerIcemaker Accessory KitTo access ice, pull the drawer out.To remove the drawer, pull it straight outand lift it past thestop location.If your refrigerator did not come alreadyequipped with an automatic icemaker,an icemaker accessory kit is available atextra cost.Check the back of the refrigerator forthe specific icemaker kit needed foryour model.9IcemakerFeeler ArmPowerSwitchGreenPower Light