Select orPress the glass gently against the top of thedispenser cradle.The spill shelf is not self-draining. To reducewater spotting, the shelf and its grille should becleaned regularly.Locking the Dispenser (on some models)Press the Crushed and Cubed keypads for 3 seconds to lock thedispenser and control panel. Tounlock, press and hold the keypads again for 3 seconds.If no water is dispensed when the refrigeratoris first installed, there may be air in the waterline system. Press the dispenser arm for atleast two minutes to remove trapped air fromthe water line and to fill the water system. Toflush out impurities in the water line, throwaway the first six glassfuls of water.CAUTION Never put fingers or anyother objects into the ice crusher dischargeopening.Dispenser LightThis pad turns the light in thedispenser on and off. The light alsocomes on when the dispensercradle is pressed. If this light burnsout, it should be replaced with a 6watt maximum, 12 volt DC bulb.About the ice and water dispenser. (On some models.) GEAppliances.comTo Use the DispenserCrushed Cubedto Lock ControlImportant Facts About Your Dispenser Do not add ice from trays or bags to the storage bin. It maynot crush or dispense well. Avoid overfilling glass with ice and use of narrow glasses.Backed-up ice can jam the chute or cause the door in thechute to freeze shut. If ice is blocking the chute, poke itthrough with a wooden spoon. Beverages and foods should not be quick-chilled in the icestorage bin. Cans, bottles or food packages in the storage binmay cause the icemaker or auger to jam. To keep dispensed ice from missing the glass, put the glassclose to, but not touching, the dispenser opening. Some crushed ice may be dispensed even though youselected Cubed. This happens occasionally when a few cubeshave been left in the crusher. After crushed ice is dispensed, some water may drip from thechute. Sometimes a small mound of snow will form on the door inthe ice chute. This condition is normal and usually occurswhen you have dispensed crushed ice repeatedly. The snowwill eventually evaporate. The first glass of water dispensed may be warmer than thefollowing ones. This is normal. Dispensed water is not ice cold. For colder water, simply addcrushed ice or cubes before dispensing water.Ice Storage Drawer on Dispenser ModelsTo remove:Slide the icemaker power switch to the OFF position.Pull the drawer straight out and then lift past the stopposition.To replace:When replacing the drawer, make sure to push it firmlyinto place. If it does not go all the way back, remove itand rotate the drive mechanism 1/4 turn. Then pushthe drawer back again.DriveMechanismRotateSpill Shelf7