GE 22-27 Owner's Manual

Customer ServiceTroubleshooting TipsOperating InstructionsSafety InstructionsInstallation InstructionsPreparing to install the refrigerator.Read these instructions completely and carefully.Water Supply to the Icemaker (on some models)If the refrigerator has an icemaker, it will have to beconnected to a cold water line.A water supply kit (containing copper tubing, shut-off valve, fittings and instructions) is availableat extra cost from your dealer or from Parts andAccessories, 800-626-2002.Refrigerator LocationDo not install the refrigerator where the tempera-ture will go below 60°F (16°C)because it will not run often enough to maintainproper temperatures.Install it on a floor strong enough to support itfully loaded.ClearancesAllow the following clearances for ease of installa-tion, proper air circulation andplumbing and electrical connections:Sides 5/8″ (15 mm)Top 1″ (25 mm)If built-in, allow 7/8″(22 mm) for hinge covers.Back 1″ (25 mm)If the refrigerator is against a wallon either side, allow the followingdoor clearances for a 90° door open-ing:22′– 25′ models 3/4″ (19 mm)27′ models 11/2″ (38 mm)RollersThe rollers have 3 purposes:Rollers adjust so the door closes easily whenopened about halfway. [Raise the front about5/8″ (15 mm) from the floor.]To assure that the doors will close automaticallyfrom a halfway open position, there is a built-in tiltfrom the front to the back of the cabinet. Side-by-side refrigerators also have specially designed doorhinges that lift both doors slightly when opened,allowing the force of gravity to help close themsecurely.Rollers adjust so the refrigerator is firmly posi-tioned on the floor and does not wobble.Rollers allow you to move the refrigerator awayfrom the wall for cleaning.To adjust the rollers, remove the base grille by pullingit out at the bottom.Turn the roller adjusting screwsclockwise to raisethe refrigerator,counterclockwise to lower it. Usean adjustable wrench (3/8″ hex head bolt) or pliers.To replace base grille, align prongs on back of grillewith clamps in cabinet and push forward until grillesnaps into place.3211790°