GE 22 Models Use And Care & Installation Manual

Also see for SIDE-BY-SIDE REFRIRATOR 22: Owners and installation manual Owner's manual Use and care & installation guide Use and care & installation guide Owner's manual

Contents

GE 22 Models Use And Care & Installation Manual Manual pdf 18 page image

PROBLEM SOLVER(continued)PROBLEMHOT AIR FROMBOTTOM OFREFRIGERATORDOOR NOT CLOSINGPROPERLYFRESH FOOD ORFREEZER COMPARTMENTTEMPERATURETOO WARMFOODS DRY OUTFROST OR ICECRYSTALS ONFROZEN FOODSLOW ICE CUBEFREEZINGICE CUBES HAVEODOR/TASTE(on some models)AUTOMATIClCEMAKERDOES NOT WORK(on some models)CUBE DISPENSERDOES NOT WORK(on some models)POSSIBLE CAUSE“ Normal air flow cooling motor. In the refrigeration process, it is normal that heatbe expelled in the area under the refrigerator. Some floor coverings will discolorat these normal and safe operating temperatures. Your floor covering suppliershould be consulted if you object to this discoloration.l Door gasket on hinge side sticking or folding over. To correct, put a smallamount of petroleum jelly on face of gasket.l Temperature control not set cold enough. Refer to Temperature Control section.Q Warm weather—frequent door openings.l Door left open for long time.l Package may be holding door open.“ Foods not covered, wrapped or sealed properly.. Door may have been left ajar or package holding door open.. Too frequent or too long door openings.l Frost within package is normal.l Door may have been left open.Q Turn temperature of freezer compartment colder.l Old cubes need to be discarded.l Ice storage bin needs to be emptied and washed,l Unsealed packages in refrigerator and/or freezer compartments may betransmitting odor/taste to ice cubes.. Interior of refrigerator needs clean ing— refer to Care and Cleaning sectionQ Poor-tasting incoming water. Install a water filter—see Water FilterAccessory section.c ON-STOP control in STOP (up) position.l Water supply turned off or not connected.Freezer compartment too warm.Cubes too small—water shutoff valve connecting refrigerator to homewater line may be clogged.Sometimes cubes fuse to the side of the ice mold and hold the feeler armSTOP (up) position. Remove this ice to restart the icemaker.in theWhen reaching for cubes by hand, you may have pushed the feeler arm into theSTOP (up) position by mistake.Piled up cubes in storage bin may cause icemaker to shut off too soon. Withicemak& feeler arm in-STOP (up) position, level cubes in bin.Q No ice cubes. Remove storage container. If cubes are frozen to wire arm,remove cubes.e No ice cubes. Icemaker turned off or water supply turned off.l Irregular ice clumps in storage container. Break up as many as you can withfingertip pressure and discard the remaining clumps.18