GE 22 Owner's Manual And Installation

Also see for SIDE-BY-SIDE REFRIRATOR 22: Owners and installation manual Owner's manual Use and care & installation guide Use and care & installation guide Owner's manual

Contents

25Installation InstructionsPUT THE REFRIGERATOR IN PLACEMove the refrigerator to its final location.4LEVEL THE DOORSAdjust the refrigerator door to make the doorseven at the top.To align:Using a 7/16” wrench, turn the door adjustingscrew to the right to raise the door, to the leftto lower it.NOTE:A nylon plug, imbedded in the threads of thepin, prevents the pin from turning unless awrench is used.After one or two turns of the wrench, openand close the refrigerator door and check thealignment at the top of the doors.6ABDoors should be even at topRaise7/16” wrenchLEVEL THE REFRIGERATORThe refrigerator can be leveled by adjusting therollers located near the bottom hinges.Rollers have three purposes:• Rollers adjust so the door closes easily whenopened about halfway. (Raise the front about5/8” [16 mm] from the floor.)• Rollers adjust so the refrigerator is firmlypositioned on the floor and does not wobble.• Rollers allow you to move the refrigeratoraway from the wall for cleaning.To adjust the rollers on 23‘ (33” wide), 25‘, 26‘,27‘ and 29‘ models:• Turn the rolleradjusting screwsclockwise to raisethe refrigerator,counterclockwiseto lower it. Use a3/8” hex socketor wrench, or anadjustable wrench.5RollersRoller adjusting screwRaiseLEVEL THE REFRIGERATOR (cont.)To adjust therollers on 23‘/ 25‘CustomStyle™ models:Turn the front rolleradjusting screwsclockwise to raisethe refrigerator,counterclockwise tolower it. Use a 3/8” hexwrench with extension, or an adjustable wrench.These models also have rear adjustablerollers so you can align the refrigerator withyour kitchen cabinets. Use a 3/8” hex wrenchwith extension to turn the screws for the rearUROOHUV³clockwise to raise the refrigerator,counterclockwise to lower it.5Roller adjusting screws