GE 36” Rangetop Installation Instructions Manual

Contents

13TOOLS AND MATERIALS REQUIRED• Gloves to protect against sharp edges• T-15 and #2 Phillips screwdrivers• Drill with 3/32” and 9/64” bits• Safety glasses• Level• PencilThis Kit Includes• Top wall support• Bottom wall support• Top cover with shelf• Bottom cover• Hardware package with– 9 Stainless Steel Torx 15 #8self-tapping screws– 9 Phillips #2 pan head wood #10 screws– 3 Stainless Steel #2 truss head#10 screws (for alternateinstallation method)WARNING:To prevent ignition of combustible materials,the entire back wall above the range must beprotected by a backsplash constructed of non-combustible material.$&&(6625,(6³” TO 36” ADJUSTABLE BACKSPLASH (not included)ZXADJB30PSS, ZXADJB36PSS, ZXADJB48PSS Accessory InstallationINSTALL THE WALL SUPPORT PANELSWARNING: The wall support panelsmust be securely fastened to the wall. Failure todo so could result in damage or personal injury.IMPORTANT: This backsplash is designed to cover the wallbetween the bottom of the hood and the top of the range.The vent hood should be installed over the rangetop orrange before installing this backsplash.• Install and level the Range/Rangetop according to theproduct installation instructions.• Remove backsplash packaging and protective film.• Locate wall studs on each side. Where studs are notavailable, plan to use wall anchors (not provided).• Use a level to pencil 2 horizontal lines on the wall, one1/8” below the vent hood and the other 1/8” above theRange/Rangetop. This 1/8” space allows the cover panelsto overlap the wall supports.• Secure the top wall support panel to the wall with 4 woodscrews, through the outermost studs.• Use 4 wood screws to secure the bottom wall supportpanel. The center slot should be positioned at the top.The gap between the top and bottom support panels will becovered by the top cover with shelf.1/8”Secure thetop panel tothe wall with 4wood screws1/8”Secure thebottom panelto the wallwith 4 woodscrewsCenterArrowWood ScrewsWoodScrewsTop WallSupportTop Coverwith ShelfBottom CoverBottom Wall SupportHardwarePackageBEFORE YOU BEGINRead these instructions completelyand carefully.IMPORTANT: Save these instructions for localinspector’s use.IMPORTANT: OBSERVE ALL GOVERNING CODES ANDORDINANCES.NOTE TO INSTALLER: Be sure to leave theseinstructions with the Consumer.NOTE TO CONSUMER: Keep these instructions withyour Owner’s Manual for future reference.• This backsplash adjusts to fit the space betweenthe top of the range and the bottom of the hood,from 30” Min. to 36” Max. height.• Maximum shelf load-bearing weight is 40 lbs.