Sound BarrierBottom Front ViewTape• With dishwasher on thewood base, check thedoor balance by openingand closing the door.• Door is properly balancedif, when opened, it selfcloses within 20° fromvertical, stays in positionfrom 20° to 70° and fallsfully open beyond 70°.Dishwasher InstallationFigure G• Screw leveling legs back into the dishwasher frame,approximately 1/2" from frame as shown.Approx.1/2"STEP 3: REMOVE WOOD BASE,INSTALL LEVELING LEGSIMPORTANT – 'RQRWNLFNRȺZRRGEDVHDamage will occur.• Move the dishwasher close to the installation location and layit on its back.• Remove the 4 leveling legs on the underside of the wood basewith a 15/16" socket wrench.• Discard base.STEP 1: PREPARATIONLocate the items in the installation package:• Screws• Junction box cover• Drain hose and clamp• Mounting brackets• Trim pieces (on some models)• Drain hose hanger• Owner's Manual• Product samples and/or couponsFigure HToekickRemove 2Toekick ScrewsSTEP 4: REMOVE TOEKICK• Remove the 2 toekick screws and toekick. Set aside for use inStep 22.Figure I6Tip: Make sure door opens and closes smoothly.Check door opening and closing. If door does not open easily orfalls too quickly, check spring cable routing. The cable is held inplace by “shoulders” on the pulley. Check to be sure cable hasnot slipped over the pulley shoulders and is routed as shown.Side ViewMake surepulley cableis withinpulleyshouldersFront View• If necessary increase or decrease tension as shown. Latchdoor and adjust both springs to the same tension setting tocorrect balance.STEP 2: CHECK DOOR BALANCEDoorcloseswithin20°Door stays inposition from20° to 70°Door falls fullyopen beyond 70°Side ViewSTEP 5: POSITION SOUND BARRIER(on some models)Skip this step if the soundbarrier is not assembledto the dishwasher.Lift the sound barrier andtape to the door front withmasking tape. This willhold the sound barrier upand out of the way duringinstallation.