Installation Instructions10DO NOT, UNDER ANYCIRCUMSTANCES, CUTOR REMOVE THE THIRD(GROUND) PRONGFROM THE POWER CORD.DO NOT USE AN ADAPTER PLUG TO CONNECT THE UNITTO A 2-PRONG OUTLET.DO NOT USE AN EXTENSION CORD WITHTHIS APPLIANCE.HARDWARE SUPPLIEDTOOLS REQUIREDTin snips to cut banding #2 Phillips screwdriverStepladderDrill and 1/2", 3/16" bitsBucket1/4", 1/2", 5/16", 7/16" socketLevelSafety glassesAppliancehand truckPliersTubing cutter Stud finder7/16" and 1-1/4"open-end wrenchGROUNDING THE UNITIMPORTANT - (Please read carefully)FOR PERSONAL SAFETY, THIS APPLIANCE MUSTBE PROPERLY GROUNDED.The power cord of this appliance is equipped witha three-prong (grounding) plug which mates witha standard three-prong (grounding) wall receptacleto minimize the possibility of electric shock hazardfrom this appliance.Have the wall outlet and circuit checked bya qualified electrician to make sure the outletis properly grounded.Where a standard 2-prong wall outlet is encountered,it is your personal responsibility and obligation to haveit replaced with a properly grounded 3-prong walloutlet.4 Washers2 Hair Pin Cotters3 lag screws5 toggles with boltsWater filterbypass plug Supplied ToekickToekick(Secured to side of unit.)Anti-Tip bracket(Secured to side of unit.)MATERIALS REQUIRED• 1/4" copper water line tubing or GE SmartConnect™Refrigerator Tubing kits• Water shut-off valve (optional but recommended)• Custom panels for door and grille panel• Screws to secure unit to cabinetry.• Stick-on hook and loop fastener strips for 1/4" sidepanelsFLOORINGFor proper installation, this product must be placedon a level surface of hard material that is at the sameheight as the rest of the flooring. This surface shouldbe strong enough to support a fully loaded refrigeratoror freezer, or approximately 1,200 lbs. per unit.NOTE: Protect the finish of the flooring. Cut a largesection of the cardboard carton and place underthe product where you are working.NOTE: Not recommended for installation on carpeted flooring.Custom handle trim