Design Guide4These units are equipped with a 2-position door stop.The factory set 130° door swing can be adjusted to 90°if clearance to adjacent cabinets or walls is restricted.Order WX14X99 door stop for precise settings between90° and 130°.When Installed into a corner:Allow 25" for a full 130° door swing. Allow 15" for panremoval. Allow 4" min. clearance when door swingis adjusted to a 90° opening for pan access, but panremoval is restricted.25"Min. toWall130°130° DoorSwingCLEARANCESZUG2, ZUGSS2 Unified Grille Panel Kit• If you are installing two units, side by side,the installation space must be 71-1/2" wide.Note: Additional cutout width may be required whenside panels are used. Add side panel thicknessto the finished cutout to calculate rough-in width.• The water and electrical locations for each productmust be located as shown.• A separate 115V, 60Hz., 15 or 20 amp power supplyis recommended for each product.Clearances for Multiple Single Door InstallationsIn a side-by-side installation of a left and right doorswing product, a 1" clearance between the units isrequired. Order ZUGSS2 Stainless Steel Unified GrillePanel Kit or ZUG2 Custom Panel Unified Grille Panel Kitfor one continuous grille panel.Clearances for two products installed side-by-sidewith the same (left or right) door swingAllow 2" minimum clearance between the productsto prevent door swing interference. Order the WX14X99adjustable door stop to reduce the factory set 130°door swing. Allow 15" minimum to a wall to achievefull drawer extension and pan removal.NOTE: ZUG2 and ZUGSS2 Grille Panel Kit will NOT fit thisinstallation.2" 15"Clearances for two products installed side-by-sidewith right and left side hinges togetherAllow 5" minimum between the two products to preventone door from striking the other. Use the WX14X99adjustable door stop to reduce the factory set 130°door swing and to allow pan removal.NOTE: ZUG2 and ZUGSS2 Grille Panel Kit will NOT fit thisinstallation.5"