GE CleanSpeak GTD81ESPJMC Technical Service Manual

Also see for CleanSpeak GTD81ESPJMC: Owner's manual Installation instructions

GE CleanSpeak GTD81ESPJMC Technical Service Manual Manual pdf 14 page image

– 14 –Reversing the Door SwingNOTE: These instructions are for changing the dryerso that the door opens from the right side.(Continued next page)Tools Needed:• Standard #2 Phillips screwdriver• Tape-tipped putty knife• 6PDOOÀDWEODGHVFUHZGULYHUBefore StartingUnplug the dryer from its electrical outlet.1. Open the door approximately 170 degrees. Witha putty knife, remove the four plastic coverslocated along the left side of the front panel andset them aside.2. Remove the bottom screw from each hinge(right side) and partially insert them into the topleft side hinge holes.NOTE: All four front panel hinge screws will now bein the top hinge holes; two on the left and two onthe right.Plastic Cover (4)Left side offront panel3. Loosen the bottom two right side hinge screws.Remove the door and place it on a protected,ÀDWVXUIDFHWRDYRLGDQ\GDPDJH5HPRYHERWKthe Blind Plate and the Strike Plate and installthem in opposite positions.4. Remove the four door hinge screws, the fouredge screws, and the eight inside screws./LIWWKHLQQHUGRRUXSZDUGVXVLQJDÀDWEODGHscrewdriver.NOTE: Some doors may have four inside screws andfour additional edge screws.Blind plateInner doorStrike plateDoor hingescrewsInner doorOuter doorInside screwsInside screwsEdgescrews