GE CleanSpeak GTD81ESPJMC Technical Service Manual

Also see for CleanSpeak GTD81ESPJMC: Owner's manual Installation instructions

GE CleanSpeak GTD81ESPJMC Technical Service Manual Manual pdf 24 page image

– 24 –NOTE: Before installing the front panel, slowly rotatethe drum in both directions to ensure that the belt isaligned and not twisted.Drum Removal1. Remove the belt from the motor pulley and idlerpulley. (See Drive Belt Removal in this guide,and follow steps 1 through 3.)2. Using the belt as a handle, pull the drumforward and guide it out of the dryer cabinet.CAUTION: To prevent damage to the dryer, the drummust be installed with the blue threaded felt sealtoward the back of the dryer.Drum RollersThe stainless steel drum rotates on four drum rollers(two on the front drum support and two on the reardrum support).Each drum roller comes as a complete assembly.Drum Roller Removal1. Remove the front bulkhead to access the frontdrum rollers. Remove the drum (See DrumRemoval in this guide), to access the rear drumrollers.2. Each drum roller is held in place by a plastictriangular clip. Remove the triangular clip with aVPDOOÀDWEODGHGVFUHZGULYHUDQGVOLGHWKHGUXPUROOHURȺWKHUROOHUVKDIWTo remove the left side drum roller shaft from thefront bulkhead:1. Remove the front bulkhead. (See Front BulkheadRemoval in this guide.)2. Remove the 9/16 in. hex nut that attaches theshaft to the front bulkhead.To remove the right side drum roller shaft fromthe front bulkhead:1. Remove the front bulkhead. (See Front BulkheadRemoval in this guide.)2. 5HPRYHWKHOLQW¿OWHU3. Disconnect the sensor wires.NOTE7KHVHQVRUURGVDUHSDUWRIWKHOLQW¿OWHUKRXVLQJ7RUHSODFHWKHVHQVRUURGVWKHOLQW¿OWHUhousing must be replaced.(Continued Next Page)Blue Thread