GE DDT595SxJ0 Series Technical Service Manual

Contents

GE DDT595SxJ0 Series Technical Service Manual Manual pdf 21 page image

– 21 –The tub gasket seals the top and sides of the tub tothe door. The retainer is part of the stainless steeltub. The seal pushes into the retainer area of thetub, and no sealant or RTV is used to install the tubgasket. When installing the tub gasket, there will bea 2 inch extension at the bottom of the tub on eachside.Tub GasketThe wiper on the Gasketmust make a smooth turnthrough the corner(Top of Dishwasher) (Front ofDishwasher)WiperFlangeTub GasketRetainer TrackCenter Position Mark(Continued next page)Tub Gasket To Remove Tub Gasket: Pull the gasket from theretainer area.Tub Gasket Installation1. The center of the gasket has a mark which isplaced pointing to the inside of the dishwasher.This position will orient the gasket wiper to facethe inside of the dishwasher and to the innerdoor.2. Start by placing the mark down and align withthe tub latch. Push the gasket into the track,working outward to the top corners.3. Push the gasket into the track through thecorners, making sure the wiper portion of thegasket does not turn inward or outward causingthe gasket to not have an even plane aroundthe corners. Stretching the gasket may causethe gasket to roll in or out, which will cause thenew gasket to leak. If the gasket wiper rolls in orout, pull the gasket out of the track and reinsertinto place.2" of tub gasket extends towardcenter of tub