GE DPGT750EC/GC Technical Service Manual

GE DPGT750EC/GC Technical Service Manual Manual pdf 23 page image

– 23 –Top CoverThe top cover is held in place by 2 Phillips headscrews, located on the back of the washer,and two front tabs.To remove the top cover:1. Remove the Backsplash.2. Remove the 2 screws that hold the Inverterbox in place.3. Place the inverter box off to the side of thedryer.4. Slide the wiring harness guard out.Disconnect the wires to the RF choke/surgeprotector.Front PanelWARNING: Sharp edges may be exposed whenthe inner top cover is removed. Use caution toavoid injury when servicing dryer. Wear Kevlargloves or equivalent protection.To remove the front panel:1. To access the 2 top Phillips head screwssecuring the front panel, remove thebacksplash and top cover.2. Open the door and remove the 4 Phillipsscrews from the front panel.6. Lift the top cover and slide it forward to clearthe front tabs.4. Lift and tilt the front panel forward slightly todisconnect wiring to the door switch.5. Remove the front panel .5. Remove the 2 rear Phillips head screws thathold the top cover in place.Door Switch3. Remove the 2 Phillips screws that hold thefront panel to the inner top cover.