GE DPGT750EC/GC Technical Service Manual

GE DPGT750EC/GC Technical Service Manual Manual pdf 24 page image

– 24 –4. Remove the 4 screws that hold the front drumsupport to the sides of the dryer.DrumWARNING: Sharp edges may be exposed.Wear Kevlar gloves or equivalent protection.The dryer drum is made of 304 stainless steeland has three replaceable drum baffles attachedto the inside. The drum rotates clockwise at 47 to50 rpm.To remove the drum:1. Remove the Top Cover and the Front Panel.2. The heat shield is held in place by 4 Phillipshead screws (2 on each side) and 2 plasticrails (1 on each side). Remove the screwsthat hold the plastic rails in place. Slide therails forward and out.Tech Tip: The drum can be removed withoutremoving the heat shield if desired. However,installation and removal of the dum can be difficultdue to the limited space around the drum if theheat shield is left in place.3. Disconnect wiring to the drum light andsensor rods.5. Grasp the top outside edges of the front drumsupport and unsnap the 4 corners from thefrom the sides of the dryer. Remove the frontdrum support.6. Remove the Drive Belt from the motor.7. Using the belt as a handle, pull the drumforward and guide it out of the dryer cabinet.Rail RailDisconnect Drum LightDisconnect Sensor RodsFront Drum Support