GE Digital Energy SG Series Installation Manual

Also see for Digital Energy SG Series: Operating manual Installation guide

Contents

g GEOPM_SGS_ISG_10K_40K_0US_V010.doc 44/45 Installation Guide SG Series 10, 20, 30 & 40 kVA4.1.7 EPO (Emergency Power Off) Input contact4132321SGT5000_100-150_Customer interface EPO_014XBJ2JP3Fig. 4.1.7-1 Terminals for connection EPOAn external Emergency switch (Normally Closedvoltage-free contact) can be connected onterminals XB / 1 - 4 or connector J2 / 12 - 25 ofthe P4 - Interface Customer.Remove the cable short-circuiting terminalsXB 2 - 3) when using this external switch.To enable this function, remove cable short-circuiting XB / 2 - 3 on theTerminal XB and the Jumper JP3 on P4 – Customer Interface, when thecables have been already connected on XB or J2.In a parallel system a separate NC (Normally Closed) contact must beconnected individually to each unit.When opened, this contact causes the immediate opening of the Contactors K3, K4, K6, K7and K8, as well as the shutdown of Rectifier, Inverter and Static-Switch.Be aware: The reliability of the system depends on this contact!After closure of the Emergency contact, a reset is necessary to enable the restart ofthe UPS, by pressing the key “O” (inverter off) on the control panel.In case of a parallel system press the key “O” (inverter off) on thecontrol panel of each unit connected on parallel bus and having it’soutput switch Q1 closed.

/ 45

Related manuals for GE Digital Energy SG Series