GE EER2001 Owner's Manual

Also see for JBP64: Owner's manual Installation instructions Owner's manual Installation instructions Owner's manual

Contents

GE EER2001 Owner's Manual Manual pdf 23 page image

Do not use a steel wool pad; it will scratchthe surface.To clean the stainless steel surface,use warm sudsy water or a stainless steelcleaner or polish. Always wipe the surfacein the direction of the grain. Follow thecleaner instructions for cleaning thestainless steel surface.To inquire about purchasing stainlesssteel appliance cleaner or polish, or tofind the location of a dealer nearest you,please call our toll-free number:National Parts Center 1.800.626.2002ge.comStainless Steel Surfaces (on some models)23Care and cleaning of the range.ge.comBe sure all controls are off and all surfaces are cool before cleaning any part of the range.If your range is removed for cleaning, servicing or any reason, be sure the anti-tipdevice is reengaged properly when the range is replaced. Failure to take thisprecaution could result in tipping of the range and cause injury.Control PanelIt’s a good idea to wipe the control panel aftereach use of the oven. Use a damp cloth toclean or rinse. For cleaning, use mild soapand water or a 50/50 solution of vinegar andwater. For rinsing, use clean water. Polish drywith a soft cloth.Do not use abrasive cleansers, strong liquidcleaners, plastic scouring pads or ovencleaners on the control panel—they willdamage the finish.Painted SurfacesPainted surfaces include the sides of therange and the door, top of control panel andthe drawer front. Clean these with soap andwater or a vinegar and water solution.Do not use commercial oven cleaners,cleaning powders, steel wool or harshabrasives on any painted surface.Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer SupportHow to Remove Protective Shipping Film and Packaging TapeCarefully grasp a corner of the protectiveshipping film with your fingers and slowly peelit from the appliance surface. Do not use anysharp items to remove the film. Remove all ofthe film before using the appliance for thefirst time.To assure no damage is done to the finishof the product, the safest way to removethe adhesive from packaging tape on newappliances is an application of a householdliquid dishwashing detergent. Apply with asoft cloth and allow to soak.NOTE: The adhesive must be removed from all parts.It cannot be removed if it is baked on.Control KnobsThe control knobs may be removed for easier cleaning.Make sure the knobs are in theOFF positionsand pull them straight off the stems forcleaning.The knobs can be cleaned in a dishwasher orthey may also be washed with soap and water.Make sure the inside of the knobs are drybefore replacing.Replace the knobs, in theOFF position toensure proper placement.