9 REHANG THE FRESH FOOD DOORTransfer thescrew cover ontop of the door tothe opposite side.Place the freshfood door on the center hinge over the pin. Assure thedoor is aligned horizontally and vertically, and that thegasket seals on all sides.Attach the top hinge removed earlier on the left side ofyour refrigerator and replace the hinge cover7 TRANSFER TOP HINGE TO THE LEFTUsing a putty knife with the edge covered withmasking tape, remove the screw cover on the left.Be careful of thepaint finish.Reinstall the screwcover on the rightside.REVERSING THE DOOR SWING (CONT.)Installation Instructions114 TRANSFER FREEZER DOOR STOP TOTHE LEFTRemove the door stop from the bottom of the rightside of the door. Transfer the screw covers from thebottom left side to the right side.Using the left doorstop included withthe parts that camewith your refrigerator,install the left doorstop.5 REHANG THE FREEZER DOORMake sure the washer(s)are in place on the bottomhinge pin. Make sure thedoor is aligned horizontallyand vertically. Place thefreezer door on the bottomhinge, close the doorand tape it in place withmasking tape.Remove the screwcovers from the leftedge of the door andinsert it into the holeon the opposite side.6 INSTALL CENTER HINGE ON THE LEFTRemove the three screwcovers on the left side andinstall two of them on theright.Using the middle hingeand screws (and washersif applicable) removedearlier, install the left middlehinge on the left side.Remove the tape holding thedoor shut.NOTICE: When assembledcorrectly, the hinge is tightagainst the cabinet.ATTENTION: The screws must be properly tightened.Turn the screws until snug. Then tighten the screws aminimum of 1/2 turn using both hands.Screw Covers Screw Cover8 TRANSFER FRESH FOOD DOORSTOP TO THE LEFTRemove the door stop fromthe bottom of the right side ofthe door. Transfer the screwcovers from the bottom leftside to the right side.Using the left door stopincluded with the parts thatcame with your refrigerator, install the left door stop.