Sound BarrierBottom Front ViewTape:LWKGLVKZDVKHURQWKHwood base, check thedoor balance by openingand closing the door.'RRULVSURSHUO\EDODQFHGif, when opened, it selfcloses within 20° fromvertical, stays in positionfrom 20° to 70° and fallsfully open beyond 70°.Dishwasher InstallationFigure G6FUHZOHYHOLQJOHJVEDFNLQWRWKHGLVKZDVKHUIUDPHapproximately 1/2" from frame as shown.Approx.1/2"STEP 3: REMOVE WOOD BASE,INSTALL LEVELING LEGSIMPORTANT – 'RQRWNLFNRȺZRRGEDVHDamage will occur.0RYHWKHGLVKZDVKHUFORVHWRWKHLQVWDOODWLRQORFDWLRQDQGOD\it on its back.5HPRYHWKHOHYHOLQJOHJVRQWKHXQGHUVLGHRIWKHZRRGEDVHwith a 15/16" socket wrench.'LVFDUGEDVHSTEP 1: PREPARATIONLocate the items in the installation package:6FUHZV-XQFWLRQER[FRYHU'UDLQKRVHDQGFODPS0RXQWLQJEUDFNHWV7ULPSLHFHV RQVRPHPRGHOV'UDLQKRVHKDQJHU2ZQHU V0DQXDO3URGXFWVDPSOHVDQGRUFRXSRQVFigure HToekickRemove 2Toekick ScrewsSTEP 4: REMOVE TOEKICK5HPRYHWKHWRHNLFNVFUHZVDQGWRHNLFN6HWDVLGHIRUXVHLQStep 22.Figure I6Tip: Make sure door opens and closes smoothly.Check door opening and closing. If door does not open easily orfalls too quickly, check spring cable routing. The cable is held inplace by “shoulders” on the pulley. Check to be sure cable hasnot slipped over the pulley shoulders and is routed as shown.6LGH9LHZMake surepulley cableis withinpulleyshoulders)URQW9LHZ,IQHFHVVDU\LQFUHDVHRUGHFUHDVHWHQVLRQDVVKRZQ/DWFKdoor and adjust both springs to the same tension setting tocorrect balance.STEP 2: CHECK DOOR BALANCEDoorcloseswithin20°Door stays inposition from20° to 70°Door falls fullyopen beyond 70°6LGH9LHZSTEP 5: POSITION SOUND BARRIER(on some models)Skip this step if the soundbarrier is not assembledto the dishwasher.Lift the sound barrier andtape to the door front withmasking tape. This willhold the sound barrier upand out of the way duringinstallation.