GE GLDT690T Installation Instructions Manual

Also see for GLDT690DBB: Owner's manual

Contents

11Installation InstructionsSTEP 14 – CONNECT POWER SUPPLYSkip this step if equipped with power cord.Verify that power is turned off at the source.•Remove junction box Cover “A”.•Locate the three dishwasher wires, (white, black andgreen) with stripped ends. Insert dishwasher wires throughthe small hole in the Junction Box “B”.•Secure house wiring to the bottom of the junction boxwith a strain Relief “C”•Use wire nuts to connect incoming ground to green, whiteto white and black to black “D”.•Replace junction box cover ”E”. check to be sure that wiresare not pinched under the cover.E. Replace Junction Box CoverWARNINGIf house wiring is not 2-wire withground, a ground must be providedby the installer . When house wiringis aluminum, be sure to use UL Listedanti-oxidant compound and aluminumto copper connectorsFigure 23WhiteGround BlackCheck That White, Black andGreen Dishwasher Wires Are ThreadedThru Hole in BackRemoveJunction BoxCoverInsert PowerCord Wires ThruStrain Reliefand TightenUse UL ListedWire NutsACBDSTEP 15 – PRE-TEST CHECKLISTReview this list after installing your dishwasher toavoid charges for a service call that is not coveredby your warranty. Check to be sure Power is OFF. Open door and remove all foam and paper packaging. Locate the Owner’s manual in the literature package. Read the Owner’s Manual for operating instructions. Check door opening and closing. If door does not openand close freely or tends to fall, check spring adjustments.See Step 1. Check to be sure that wiring is secure under thedishwasher , not pinched or in contact with door springs orother components. See Step 9. Check door alignment with tub. If door hits tub, leveldishwasher . See Step 10. Pull lower rack out, about half way . Check to be sure itdoes not roll back or forward on the door. If the rack moves,adjust leveling legs. See Step 10. Check door alignment with cabinet. If door hitscabinet, reposition or relevel dishwasher . See Step 10. Verify water supply and drain lines are not kinked orin contact with other components. Contact with motor ordishwasher frame could cause noise. See Step 8. Turn on the sink hot water faucet and verify watertemperature. Incoming water temperature Mustbe between 120° F and 150 F. A Minimum of 120 Ftemperature is required for best wash performance. See“Prepare Hot Water Line”, page 5. Add 2 quarts of water to the bottom of the dishwasherto lubricate the pump seal. Turn on water supply. Check for leaks. Tightenconnections if needed. Remove protective film if present from the controlpanel and door..