GE GLDT690T Installation Instructions Manual

Also see for GLDT690DBB: Owner's manual

Contents

6Installation InstructionSTEP 2 – ADJUST LEVELING LEGS•Move the dishwasher close to the installationlocation and lay it on its back.•Measure installation height and dishwasher height.Extend leveling legs out from the dishwasher base,1/4”less than installation height.Figure 8Adjust toInstallationHeightAdjust toInstallationHeightSTEP 3 – REMOVE TOEKICK•Remove the 2 toekick screws. Lift off the 2 piecetoekick.Figure 92-ScrewsSTEP 4 – INSTALL POWER CORDSkip this step if dishwasher will be direct wired.The power cord and connections must comply withthe National Electrical Code, Section 422and/or localcodes and ordinances.Recommended power cord length is 54” min. and 64” max.Connect incomingpower cord white (or ribbed)to dishwasher white. Black(or smooth) to black. Ground to dishwasher greenwire. Use UL listed wire nuts of appropriate size.Replace junction box cover . Be sure wires are notpinched under the cover .WhiteGround BlackCheck That White, Black andGreen Dishwasher Wires Are ThreadedThru Hole in BackRemoveJunction BoxCoverInsert PowerCord Wires ThruStrain Reliefand TightenUse UL ListedWire NutsACBDFigure 10STEP 5 – INSTALL 90° ELBOWWrap 90 elbow with thread seal tape.Install a 90 elbow onto the water valve.•Do not over Tighten 90° elbow, water valve bracketcould bend or water valve fitting could break.•Position the end of the elbow to face the rear of thedishwasher .Figure 1190ElbowFillHoseThreadSeal TapeWaterValveBracket