GE GNE26 series Owner's Manual And Installation Instructions

Also see for DFE29: Owner's manual and installation instructions Quick use guide Owner's Manual & Installation Instructions Owner's manual and installation instructions

GE GNE26 series Owner's Manual And Installation Instructions Manual pdf 23 page image

23Installation InstructionsINSTALLING THE REFRIGERATORREFRIGERATOR LOCATION• Do not install the refrigerator where the temperaturewill go below 60°F (16°C) because it will not run oftenenough to maintain proper temperatures.• Do not install the refrigerator where the temperaturewill go above 100°F (37°C) because it will not performproperly.• Install it on a floor strong enough to support it fullyloaded.CLEARANCESAllow the following clearances for ease of installation,proper air circulation and plumbing and electricalconnections.Sides 1/8” (3 mm)Top 1” (25 mm) Cabinet/Hinge CoverBack 2” (50 mm)REMOVE THE FRESH FOODDOOR HANDLEHandle Design varies based on models, howeverInstallation is same.Stainless steel and plastic handles:Loosen the set screws with the 1/8” Allen wrenchand remove the handle.NOTE: If the handle mounting fasteners need to betightened or removed, use a 1/4” Allen wrench.1REMOVE THE FREEZER DOOR HANDLEHandle Design varies based on models, howeverInstallation is same.Stainless steel and plastic handles:Loosen the set screws with the 1/8” Allen wrench andremove the handle.NOTE: If the handle mounting fasteners need to betightened or removed, use a 1/4” Allen wrench.2MountingFastenersLeave filmon until afterinstallationMountingFastenersLeave filmon until afterinstallationReinstall the handles using the same procedure asremoving.REMOVING THE REFRIGERATOR DOORS• IMPORTANT NOTE: This refrigerator is 361/4” deep (311/4”for CD models). Doors and passageways leading to theinstallation location must be at least 361/4” wide in order toleave the doors and handles attached to the refrigeratorwhile transporting it into the installation location. Ifpassageways are less than 361/4”, the refrigerator doorsand handles can easily be scratched and damaged.The top cap and doors can be removed to allow therefrigerator to be safely moved indoors. If passagewaysare less than 311/4”, start with Step 1.• If it is not necessary to remove doors, skip to Step11. Leave tape and all packaging on doors until therefrigerator is in the final location.• NOTE: Use a padded hand truck to move this refrigerator.Place the refrigerator on the hand truck with a sideagainst the truck. We strongly recommend that TWOPEOPLE move and complete this installation.www.goedekers.com