GE GSF25JGC Owner's Manual & Installation Instructions

Installation Instructions Models 20, 22, 25BEFORE YOU BEGINRead these instructions completely and carefully.• IMPORTANT – Save these instructionsfor local inspector’s use.• IMPORTANT – Observe all governingcodes and ordinances.• Note to Installer – Be sure to leave theseinstructions with the Consumer.• Note to Consumer – Keep these instructions forfuture reference.• Skill level – Installation of this appliance requires basicmechanical skills.• Completion time – Refrigerator Installation15 minutes• Proper installation is the responsibility of installer.• Product failure due to improper installation is notcovered under the Warranty.REFRIGERATOR LOCATION• Do not install the refrigerator where the temperature willgo below 60°F (16°C) because it will not run often enoughto maintain proper temperatures.• Install it on a floor strong enough to support it fullyloaded.Allow the following clearances for ease of installation,proper air circulation and plumbing and electrical connections.• Sides 1/8″ (4 mm) • Top 1″ (25 mm) • Back 1″ (25 mm)A door clearance of 3/4″ (19 mm) is needed for a 90º dooropening which provides better access to food storage area.CLEARANCESIf the refrigerator has an icemaker, it will have to beconnected to a cold water line. A GE water supply kit isavailable at extra cost from your dealer, by visiting ourWebsite at GEAppliances.com (in Canada, atwww.GEAppliances.ca), or from Parts and Accessories,800.626.2002.WATER SUPPLY TO THE ICEMAKER (on somemodels )Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: GEAppliances.comQuestions? In Canada, call 1.800.561.3344 or Visit our Website at: www.geappliances.caThe rollers have 3 purposes:Rollers adjust so the door closes easily when opened abouthalfway.Rollers adjust so the refrigerator is firmly positioned on thefloor and does not wobble.Rollers allow you to move the refrigerator away from thewall for cleaning.To adjust the rollers, remove the base grille by pulling it out atthe bottom.Turn the roller adjusting screws clockwise to raise therefrigerator, counterclockwise to lower it. Use an adjustablewrench (3/8″ hex head bolt) or pliers.To replace base grille, line up the clips on back of grillebetween the bar and the bottom of the cabinet. Push forwarduntil grille snaps into place.ROLLERS10To remove the basegrille, open the doorsand then pull thegrille straight out.5/16″ SocketWrenchRaiseDOOR ALIGNMENTAfter leveling, make sure that doors are even at the top.To make the doors even, adjust the refrigerator door.Using a 5/16″ socket wrench, turn the door adjusting screwto the right to raise the door, to the left to lower it. (A nylonplug, embedded in the threads of the pin, prevents the pinfrom turning unless a wrench is used.)After one or two turns of the wrench, open and close therefrigerator compartment door and check the alignment atthe top of the doors.