- Risk of Fire• Clothes dryer installation must be performed by aqualified installer.• Install the clothes dryer according to these instructionsand local codes.• DO NOT install a clothes dryer with flexible plastic ventingmaterials. If flexible metal (semi-rigid or foil-type) duct isinstalled, it must be UL-listed and installed in accordancewith the instructions found in “Connecting the Dryerto House Vent” later in this manual. Flexible ventingmaterials are known to collapse, be easily crushed andtrap lint. These conditions will obstruct dryer airflow andincrease the risk of fire.• DO NOT install or store this appliance in any locationwhere it could be exposed to water or weather.• To reduce the risk of severe injury or death, follow allinstallation instructions.• Save these instructions. (Installers: Be sure to leavethese instructions with the customer.)In the Commonwealth of Massachusetts,the following installation instructions apply:• Installation must be performed by a qualified orlicensed contractor, plumber, or gasfitter qualifiedor licensed by the State.• If using a ball valve, it shall be a T-handle type.• A flexible gas connector, when used, must notexceed 4 feet.FOR GAS DRYERS ONLYBEFORE YOU BEGINRead these instructions completely and carefully.IMPORTANT – Save these instructions for local electricalinspector’s use.IMPORTANT – Observe all governing codes andordinances.• Install the clothes dryer according to the manufacturer’sinstructions and local codes.• Note to Installer – Be sure to leave these instructionswith the Consumer.• Note to Consumer – Keep these instructions for futurereference.• Clothes dryer installation must be performed by a qualifiedinstaller.• This dryer must be exhausted to the outdoors.• Before the old dryer is removed from service or discarded,remove the dryer door.• Do not allow children on or in the appliance. Closesupervision of children is necessary when the applianceis used near children.• Proper installation is the responsibility of the installer.• Product failure due to improper installation is notcovered under the Warranty.• Install the dryer where the temperature is above 50°F forsatisfactory operation of the dryer control system.• Remove and discard existing plastic or metal foil ductand replace with UL-listed duct.• Service information and the wiring diagram are locatedin the control console.Questions? Call GE Appliances at 800.GE.CARES (800.432.2737) or visit our Web site at: GEAppliances.comDryersInstallation InstructionsWARNINGFailure to follow safety warnings exactly couldresult in serious injury, death, or property damage.- DO NOT store or use gasoline or otherflammable vapors and liquids in the vicinity ofthis or any other appliance.- WHAT TO DO IF YOU SMELL GAS:• DO NOT try to light any appliance.• DO NOT touch any electrical switch; DO NOTuse any phone in your building.• Clear the room, building, or area of any occupants.• Immediately call your gas supplier from a neighbor’sphone. Follow the gas supplier’s instructions.• If you cannot reach your gas supplier, call thefire department.- Installation and service must be performed bya qualified installer, service agency, or the gassupplier.- Fire or ExplosionHazardWARNING31-16775-5 05-21 GEA234D2318P005