Consumer Support Troubleshooting Tips Operating Instructions Safety InstructionsInstallation Instructions28Problem Possible Causes What To DoAutomatic icemaker Icemaker power switch is •On power switch models, set the power switch to the(on some models) not on. I (on) position. On feeler arm models, move the feelerdoes not work arm to the ON (down) position.Water supply turned off or •See Installing the water line.not connected.Freezer compartment •Wait 24 hours for the refrigerator to completelytoo warm. cool down.Piled up cubes in the storage •Level cubes by hand.bin cause the icemakerto shut off.Ice cubes stuck in icemaker. •Turn off the icemaker, remove cubes and turn the(Green power light on icemaker back on.icemaker blinking.)Ice cubes have Ice storage bin needs cleaning. •Empty and wash bin. Discard old cubes.odor/taste Food transmitting odor/taste •Wrap foods well.to ice cubes.Interior of refrigerator •See Care and cleaning.needs cleaning.Slow ice cube freezing Door left open. •Check to see if package is holding door open.Temperature control not set •See About the controls.cold enough. •A newly installed refrigerator may take 12–24 hoursto begin making ice cubes.Moisture forms on Not unusual during •Wipe surface dry; then adjust the fresh food controlcabinet surface periods of high humidity. setting one number higher and check again in 24 hours.between the doorsRefrigerator has odor Foods transmitting • Foods with strong odors should be tightly wrapped.odor to refrigerator. • Keep an open box of baking soda in the refrigerator;replace every three months.Interior needs cleaning. • See Care and cleaning.Moisture collects inside Too frequent or too(in humid weather, air long door openings.carries moisture into Open containers of water or • Cover or seal open containers. During a defrost cycle,refrigerator when doors warm food in the refrigerator. moisture will be removed from the refrigerator, but mayare opened) return with long or frequent door openings.Refrigerator compartment No power at outlet. •Replace fuse or reset the breaker.light does not work Light bulb burned out or loose. •See Replacing the light bulbs.Before you call for service…Troubleshooting Tips