GE GTH22KBR Owner's Manual & Installation Instructions

Also see for GTH22KBR: Owner's Manual & Installation Instructions Specifications

20TRANSFER REFRIGERATORDOOR HANDLE TO THE RIGHTTo remove the handle: Remove the plug button bycarefully prying under the edge with a putty knife.Remove the exposed screw holding the handle.7Remove the two screws holding the handle to thetop of the door.After removing the handle: Move the small plugbuttons from the top right side of the door top andinsert them into the holes on the opposite side.Small PlugButtonsMove the large plug button from the left edge of thedoor and insert it into the hole on the opposite side.Plug ButtonHandlePlugHandlePlugPinHoleHandle PlugShortScrewShort HandleLong HandleREVERSING THE DOOR SWING (CONT.)Installation InstructionsTRANSFER CENTER HINGEBRACKET TO THE LEFTRemove the center hinge bracket by removingthe three screws.NOTE: Keep these screws with the hinge bracket.They are long screws and will be used when installingthe hinge on the other side.You will need to remove the color-matched cap fromthe screw head before you can remove the screw.Use the edge of a thin flat blade to gently pry thecaps off the screw heads. (A putty knife works wellfor this.) Cover the blade with tape to preventscratching the paint.Remove the mullion cover from the left side usingthe thin flat blade. Assemble it to the right side.Remove the screw from the center left side of thecabinet. Screw it into the holes on the right side.Place the center hinge bracket over the holes atthe center left side of the cabinet. Insert andtighten the three long screws.Replace the cap by snapping it over the screw withyour finger.5TRANSFER DOOR STOPSOn each door, move the metal door stop from theright to the left.Move any screws from the left to the right.6Screw CapMullion Cover