12-Hour ShutdownWith this feature, should you forget and leave theoven on, the control will automatically turn off theoven after 12 hours during baking functions orafter 3 hours during a broil function.If you wish to turn OFF this feature, followthe steps below.Touch the BAKE and BROIL HI/LOpads at the same time until thedisplay shows SF.Touch the DELAY START pad untilno shdn (no shut-off) appears in thedisplay.Touch the START pad to activate theno shut-off and leave the controlset in this special features mode.Fahrenheit or Celsius Temperature SelectionYour oven control is set to use the Fahrenheittemperature selections but you may change thisto use the Celsius selections.Touch the BAKE and BROIL HI/LOpads at the same time until thedisplay shows SF.Touch the COOKING TIME and BROILHI/LO pads at the same time. Thedisplay will show F (Fahrenheit).Touch the COOKING TIME and BROILHI/LO pads again at the same time.The display will show C (Celsius).Touch the START pad.Tones at the End of a Timed CycleAt the end of a timed cycle, 3 short beeps willsound followed by one beep every 6 secondsuntil the CLEAR/OFF pad is touched. Thiscontinual 6-second beep may be canceled.To cancel the 6-second beep:Touch the BAKE and BROIL HI/LOpads at the same time until thedisplay shows SF.Touch the KITCHEN TIMER ON/OFFpad. The display shows CON BEEP(continuous beep). Touch theKITCHEN TIMER ON/OFF pad again.The display shows BEEP. (This cancelsthe one beep every 6 seconds.)Touch the START pad.Cook and HoldYour new control has a cook and hold feature thatkeeps cooked foods warm for up to 3 hours afterthe cooking function is finished.To activate this feature, follow thesteps below.Touch the BAKE and BROIL HI/LOpads at the same time until thedisplay shows SF.Touch the COOKING TIME pad.The display will show Hld OFF.Touch the COOKING TIME pad againto activate the feature. The displaywill show Hld ON.Touch the START pad to activatethe cook and hold feature andleave the control set in thisspecial features mode.Special features of your oven control. GEAppliances.comYour new touch pad control has additional features that you may choose to use. The following are the featuresand how you may activate them.The special feature modes can only be activated while the display is showing the time of day. They remainin the control’s memory until the steps are repeated.When the display shows your choice, touch the START pad. The special features will remain in memory aftera power failure, except for the Sabbath feature, which will have to be reset.Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support17