GE JB960 B Technical Service Manual

Also see for JB940: Installation instructions Installation instructions Owner's manual Owner's manual Owner's manual

GE JB960 B Technical Service Manual Manual pdf 22 page image

– 20 –CONTROL PANELThe electronic touch controls, located on the frontof the control console, are capacitance touchdesign. The crystal keypanel assembly has thecapacitance touch circuit board bonded to itssurface on the rear side.Keypanel Removal1. Remove power to the unit.2. Remove all four control knobs.3. Remove the four nylon retainer nuts whichsecure the crystal keypanel assembly tothe control console. Important note:when reinstalling the nylon retainer nuts,tighten only hand tight. Be sure that eachnylon retainer nut is flush with the glasskeypanel (the shoulder of the nylon re-tainer nut is seated into the glasskeypanel). Over tightening can damagecrystal keypanel assembly.4. With all four nuts removed, the keypanelassembly can now be pulled away fromthe control console to gain access to theconnector plug. This plug connects thekeypanel to the ERC (Electronic RangeControl).Control Panel Access1. Remove power to the unit.2. Lay a protective cloth on the cooktop sur-face.3. To obtain access to the control panel com-ponents, remove the four screws whichsecure it to the range frame (see illustra-tion to the right). Gently pull forward fromthe bottom the control panel while liftingupward.4. Lay the control panel on the protectedcooktop surface (components facing up-ward).Infinate Heat Switch Removal1. Remove power to the unit.2. Remove the crystal keypanel assemblyfollowing the steps listed above.3. Remove the crystal mounting plate whichsecures the infinate heat switch to the con-trol console (2 small phillips head screws).CONTROL PANELACCESSCONTROLKNOBNYLONRETAINERNUTCRYSTALMOUNTINGPLATE