Safety Instructions Operating InstructionsSafety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer SupportCare and cleaning of the range.GEAppliances.comBe sure all controls are off and all surfaces are cool before cleaning any part of the range.Control KnobsThe control knobs may be removed for easiercleaning.Before removing the knobs for cleaning,please note that the knobs are in theOFF position. When replacing the knobs,check theOFF position to insure properplacement.Wash the knobs in soap and water ora vinegar and hot water solution butdo not soak.How to Remove Packaging TapeTo assure no damage is done to the finishof the product, the safest way to removethe adhesive left from packaging tape onnew appliances is an application of ahousehold liquid dishwashing detergent,mineral oil or cooking oil.Apply with a soft cloth and allow to soak.Wipe dry and then apply an appliancepolish to thoroughly clean and protectthe surface.NOTE: The plastic tape (on some models) mustbe removed from all chrome trim. It cannot beremoved if it is baked on.If your range is removed for cleaning, servicing or any reason, be sure the anti-tipdevice is re-engaged properly when the range is replaced. Failure to take thisprecaution could result in tipping of the range and cause injury.Control PanelDeactivate the touch pads before cleaning.See theCooking/Self-Clean lockoutinformation in theSpecial features ofyour oven control section in this manual.Clean up splatters with a damp cloth.You may also use a glass cleaner.Remove heavier soil with warm soapywater. Do not use abrasives of any kind.Reactivate the touch pads after cleaning.See theCooking/Self-Clean lockoutinformation in theSpecial featuresof your oven control section in thismanual.Oven VentThe oven vent is located behind the right rearsurface unit.This area could become hot duringoven use.It is normal for steam to come outof the vent and moisture may collectunderneath it when the oven is in use.The vent is important for proper air circulation.Never block this vent.5Molded flat areaFlatFlat Stem27Spring clipClear groovein stemMolded ribGroove Stem The knob stem has a groove in eachside. The groove on one side has aspring clip. The other groove is clear(see illustration). Check the inside ofthe knob and find the molded rib.Replace the knob by fitting the moldedrib inside the knob into the cleargroove on the stem.The knob stem is flat on one side (seeillustration). Check the inside of theknob and find the molded flat area.Replace the knob by fitting the moldedflat area inside the knob onto the flatarea of the stem.