CAUTION:Beforereplacing your oven light bulb, turn the ovenlight off and disconnect the electrical powerto the range at the main fuse or circuitbreaker panel.Be sure to let the light cover and bulb coolcompletely.To remove the cover:Hold a hand under the cover so itdoesn’t fall when released. With fingersof the same hand, firmly push backthe wire cover holder. Lift off the cover.Do not remove any screws to removethe cover.Replace bulb with a 40-watt householdappliance bulb.To replace the cover:Place it into groove of the lightreceptacle. Pull wire forward tothe center of the cover until it snapsinto place.Connect electrical power to the range.Wire cover holderOven Light Replacement (on some models)Pull the drawer out all the way.Tilt up the front and remove it.Insert glides at the back of the drawerbeyond the stop on range glidLift the drawer if necessary toeasily.Let the front of the drawer down; thenpush in to close.Clean under the range.Storage Drawer Removal (on some models)Care and cleaning of the range.To remove the storage drawer: To replace the storage drawer:Oven Heating Elements(on some models)Oven rackDo not clean the bake element or the broilelement. Any soil will burn off when theelements are heated.To clean the oven floor, gently liftthe bake element Clean with warmsoapy waterOn some models, the bake element is notexposed and is under the oven floor. If spilloverresidue or ash accumulate on theoven floor,wipe up before self-cleaning.Oven RacksAll oven racks may be cleaned by hand with anabrasive cleaner or steel wool After cleaning,rinse the racks with lean water and drywith aclean cloth Gray porcelain-coated oven racksmay remain in the oven during the self-cleaningcycle without being damaged The shiny,silver colored oven racks may remain in theoven during the self-cleaning cycle, but theywill lose their luster and become hard to slide.It will be necessary to grease all ovenrack side edges with a light coating ofsliding the racks in and out of the oven27Consumer SupportTroubleshooting TipsCare and CleaningOperating InstructionsSafety Instructions