GE JCS905 Owner's Manual

Also see for JCS905: Owner's manual

GE JCS905 Owner's Manual Manual pdf 21 page image

Care and cleaning of the range. www.GEAppliances.caBe sure all controls are off and all surfaces are cool before cleaning any part of the range.WARNING: If your range is removed for cleaning, servicing or anyreason, be sure the anti-tip device is reengaged properly when the range is replaced.Failure to take this precaution could result in tipping of the range and cause injury.Control KnobsThe control knobs may be removed for easiercleaning.Make sure the knobs are in the OFFpositions and pull them straight off thestems for cleaning.The knobs can be cleaned in adishwasher or they may also be washedwith soap and water. Make sure the insidesof the knobs are dry before replacing.Replace the knobs in the OFF positionto ensure proper placement.Oven VentThe oven vent is located above the left side ofthe door.This area could become hot duringoven use.It is normal for steam to come out ofthe vent.The vent is important for proper air circulation.Never block this vent.Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer SupportStainless Steel Surfaces (on some models)Do not use a steel wool pad; it will scratchthe surface.To clean the stainless steel surface,use warm sudsy water or a stainless steelcleaner or polish. Always wipe the surfacein the direction of the grain. Follow thecleaner instructions for cleaning thestainless steel surface.To inquire about purchasing stainlesssteel appliance cleaner or polish, or tofind the location of a dealer or MabeParts Store nearest you, please call ourtoll-free number:National Parts Centre 1.800.661.1616www.GEAppliances.ca21How to Remove Protective Shipping Film and Packaging TapeCarefully grasp a corner of the protectiveshipping film with your fingers and slowlypeel it from the appliance surface. Donot use any sharp items to remove thefilm. Remove all of the film before usingthe appliance for the first time.To assure no damage is done to thefinish of the product, the safest way toremove the adhesive from packagingtape on new appliances is an applicationof a household liquid dishwashingdetergent. Apply with a soft cloth andallow to soak.NOTE: The adhesive must be removed from allparts. It cannot be removed if it is baked on.Painted SurfacesPainted surfaces include the door, top ofthe control panel and the drawer front.Clean these with soap and water or avinegar and water solution.Do not use commercial oven cleaners,cleaning powders, steel wool or harshabrasives on any painted surface.