GE JCS968 Owner's Manual

Also see for JCS968: Owner's manual Owner's manual

GE JCS968 Owner's Manual Manual pdf 29 page image

29Control PanelIf desired, the touch pads may be deactivatedbefore cleaning.See the Cooking/Self-Clean lockoutinformation in the Special features ofyour oven control section in this manual.Clean up splatters with a damp cloth.You may also use a glass cleaner.Remove heavier soil with warm soapywater. Do not use abrasives of any kind.Reactivate the touch pads after cleaning.Care and cleaning of the range. www.geappliances.caBe sure all controls are off and all surfaces are cool before cleaning any part of the range.Control KnobsThe control knobs may be removed for easiercleaning.Make sure the knobs are in the OFFpositions and pull them straight off thestems for cleaning.The knobs can be cleaned in adishwasher or they may also be washedwith soap and water. Make sure the insidesof the knobs are dry before replacing.Replace the knobs in the OFF positionto ensure proper placement.If your range is removed for cleaning, servicing or any reason, be sure the anti-tipdevice is reengaged properly when the range is replaced. Failure to take thisprecaution could result in tipping of the range and cause injury.Oven VentThe oven vent is above the left side of the door.This area could become hot duringoven use.It is normal for steam to come out ofthe vent.The vent is important for proper air circulation.Never block this vent.Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer SupportHow to Remove Protective Shipping Film and Packaging TapeCarefully grasp a corner of the protectiveshipping film with your fingers and slowlypeel it from the appliance surface. Do notuse any sharp items to remove the film.Remove all of the film before using theappliance for the first time.To assure no damage is done to thefinish of the product, the safest way toremove the adhesive from packaging tapeon new appliances is an application of ahousehold liquid dishwashing detergent.Apply with a soft cloth and allow to soak.NOTE: The adhesive must be removed from allparts. It cannot be removed if it is baked on.