GE JGB928 Owner's Manual & Installation Instructions

Also see for JGB928: Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions

GE JGB928 Owner's Manual & Installation Instructions Manual pdf 14 page image

Power OutageIf a flashing time is in the display, you haveexperienced a power failure. Reset the clock.To reset the clock, touch the CLOCK pad.Enter the correct time of day by touchingthe appropriate number pads. Touch theSTART pad.Operating Instructions Safety InstructionsInstallation InstructionsTroubleshooting TipsConsumer Support14Not all features are on all models.To Set the ClockThe clock must be set to the correct time ofday for the automatic oven timing functionsto work properly. The time of day cannotbe changed during a timed baking or self-cleaning cycle.Touch the CLOCK pad.Touch the number pads.Touch the number pads the same way youread them. For example, to set 12:34, touchthe number pads 1, 2, 3 and 4 in that order.If number pads are not touched within oneminute after you touch the CLOCK pad, thedisplay reverts to the original setting. If thishappens, touch the CLOCK pad and reenterthe time of day.Touch the START pad until the time ofday shows in the display. This entersthe time and starts the clock.To check the time of day when the display isshowing other information, simply touch the CLOCKpad. The time of day shows until another pad istouched.Make sure the clock is set to thecorrect time of day.To Set the TimerThe timer does not control oven operations.The maximum setting on the timer is 9 hoursand 59 minutes.Touch the KITCHEN TIMER ON/OFFpad.Touch the number pads until theamount of time you want shows in thedisplay. The maximum time that canbe entered in minutes is 59. Timesmore than 59 minutes should bechanged to hours and minutes. Forexample, to enter 90 minutes as 1hour 30 minutes, touch 1, 3 and 0 inthat order.If you make a mistake, press the KITCHEN TIMERON/OFF pad and begin again.Touch the START pad. After pressingthe START pad, SET disappears; thistells you the time is counting down,although the display does not changeuntil one minute has passed.When the timer reaches :00, thecontrol will beep 3 times followed byone beep every 6 seconds until theKITCHEN TIMER ON/OFF pad is touched.The 6 second tone can be canceled by followingthe steps in the Special features of your ovencontrol section under Tones at the End ofa Timed Cycle.The timer is a minute timer only.The CLEAR/OFF pad does not affectthe timer.To Reset the TimerIf the display is still showing the timeremaining, you may change it by touchingthe KITCHEN TIMER ON/OFF pad, then touchthe number pads until the time you wantappears in the display.If the remaining time is not in the display(clock, delay start or cooking time are inthe display), recall the remaining time bytouching the KITCHEN TIMER ON/OFF padand then touching the number pads toenter the new time you want.To Cancel the TimerTouch the KITCHEN TIMER ON/OFFpad twice.Using the clock and timer.