GE JGGN24 Owner's Manual

Also see for JGGB27: Assembly instructions

Contents

GE JGGN24 Owner's Manual Manual pdf 8 page image

8Operating Instructions Safety InstructionsCare and CleaningTroubleshooting TipsConsumer SupportBefore Lighting the GrillnThe grill must be assembled inaccordance with the AssemblyInstructions.nCheck that your LP tank is full andproperly connected to the regulator.nCheck that there are no gas leaks inthe gas supply system. See the LeakTesting section.nCheck that the venturi tubes are properlylocated over the gas valve orifices.nCheck that both Main Burner and SideBurner ignition wires are connected.nRead carefully all instructions containedon the rating plate.CAUTION: Check your grillafter lighting. All the ports on the burnershould show a 1 ″(2.5 cm) flame on HIsetting.nIf any of the following symptoms occur,there is probably a blockage in theventuri tubes. Shut off gas at once andclean the venturi tubes. See the Venturitubes section.1. You smell gas.2. If a flashback fire occurs.3. Your grill heats unevenly.4. The burners make popping noises.TO LIGHT WITH THE IGNITOR:1. Make sure control knobs are set toOFF and turn on the gas supply byopening the LP tank valve.2. Push and turn right control knobtoHI.3. Push the ignitor button 3 or 4 times.The burner should ignite within4 seconds.After the right burner is lit, pushand turn left control knob toHI.Left burner will ignite automatically.TO LIGHT WITH A MATCH:1. Make sure control knobs are set toOFF and turn on the gas supply byopening the LP tank valve.2. Insert lighted match through lightinghole located at the bottom right of thegrill housing.3. Push and turn right control knob toHI. The burner should ignite within4 seconds.After the right burner is lit, pushand turn left control knob toHI.Left burner will ignite automatically.Check Flame BurnerBurner PortHIOFFIGNITORLEFTLOHIOFFRIGHTLOLighting the grill.Lighting the Main BurnersWARNING: Open lid before lighting.If the Main Burner Will Not Light1. Turn control knobs toOFF.Wait 5 minutes, then try again.2. If any burner will not light, consulttheTroubleshooting Tips section atthe back of this manual. If problemcannot be resolved, do not attemptto operate the grill. Contact aGE Authorized Service Center.Shutting Down1. Turn off the gas supply by closingthe LP tank valve.2. Turn control knobs toOFF.