14LP ConversionG3 Changing the CooktopBurner Orifices:a. Remove the top grates, burner caps and burnerheads.b. Using a 7mm or 9/32" nut driver, remove thetop burner orifices. These may be accessedthrough the burner air/gas mixer tube(Chimney).RETAINERRINGc. Locate the LP/Propaneorifices shipped insidethe literature package.They will have a digitnumber and the letter “L”on the side. (Important:Save the orifices removedfrom the appliance for future use.)Each orifice will show a series of engravedmarks, (l,II or III), located on the top.I II IIId. Install the LP/Propane orifices in theirprecise locations as noted in the illustrationsabove.e. Return the natural orifices to the bracket andreattach the bracket and the instructionsheet to the pressure regulator using thescrew previously removed.f. Replace the burner heads, caps and topgrates.continued on following pageBURNERBOWLSPARK IGNITERBURNER GRATEBURNER CAPBURNER HEADMIXER TUBE(CHIMNEY)MIXER TUBEThese marks denote the precise locationof each orifice to the cooktop burner.NOTE: The orifices have a spring loadedretaining ring around the hex head to holdthe orifice in the nut driver duringinstallation and removal. A slight amountof force is required to push the nut driverdown over the ring.MIXER TUBE (CHIMNEY)Glass CooktopIIIIIlllPorcelain CooktopIIIIIllMaking the L.P. Conversion cont.G