GE JGP633SETSS Installation Instructions Manual

Also see for JGP970: Installation instructions Owner's manual Owner's manual Owner's manual Installation instructions

Contents

13Installation InstructionsMAKING THE LP CONVERSIONSAFETY INFORMATION YOUSHOULD KNOWThe pressure regulator and burner orificesare set for natural gas. To use Propane Gas,the regulator and burner orifices must beconverted. The LP orifice spuds for thecooktop burners can be located in theliterature package attached to the regulator.CAUTION: The cooktop, as shippedfrom the factory, is set for use with naturalgas. If you wish to use your cooktop withLiquefied Petroleum (Propane) gas, you mustfirst replace the orifices and convert thepressure regulator.WARNING: This conversion mustbe performed by a qualified installer or gassupplier in accordance with the manufacturer’sinstructions and all codes and requirementsof the authority having jurisdiction. Failureto follow instructions could result in seriousinjury or property damage. The qualifiedagency performing this work assumesresponsibility for the conversion.CAUTION: The following adjustmentsmust be made before turning on the burner.Failure to do so could result in serious injury.Be sure pressure regulator has beenconverted as described in Step 2.1 ADJUST YOUR COOKTOP FORUSE WITH LP GASDisconnect all electrical power, at themain circuit breaker or fuse box.Shut off the gas supply to the cooktopby closing the manual shut-off valve.Adjust the pressure regulator, by thefollowing instructions:• Unscrew the cap.• Place your thumb against the flat sideof the spring retainer and press downto remove the retainer.• Carefully look at the spring retainer tolocate the NAT or LP position.• Turn the spring retainer over so thatLP is showing on the bottom.• Snap the retainer back into position.• Screw the cap back onto the regulator.CBA2DOWNFOR OFFNATLPLPNATLPNATNATLPGasketCapSpringRetainerL.P./PropanePositionNAT.PositionPressure RegulatorTOOLS YOU WILL NEEDFOR LP CONVERSIONSafety GlassesSmall Flat-HeadScrewdriver (4mmor 5/32″ tip size,60mm long)Phillips HeadScrewdriverPliers7mm NutdriverNo. 15 Torx-HeadDriver