GE JKP70BM Dimensions And Installation Information

Also see for JKP70BM: Specification sheet Brochure

Contents

installation dimensions

GE JKP70BM Dimensions And Installation Information Manual pdf 1 page image

For answers to your Monogram,® GE Profile™ orGE® appliance questions, visit our website atge.com or call GE Answer Center® service,800.626.2000.320436Specification Revised 10/07JKP70BM/WMGE® 27" Built-In Single Convection Wall OvenListed byUnderwritersLaboratoriesKW Rating240V 3.4208V 2.6Breaker Size240V 20 Amps208V 20 Amps AccessfromadjacentcabinetrequiredSuitablebracingto supporrunners2" x 4"or equiv.runnersB MIN.C MIN.Conduit 48-1/2" long32-1/2D10A Allow 3/4"for overlapover all edgesof cutoutLocatejunction boxeither 5" MIN.below cutoutfloor or 44"MIN. abovecutout floorMinimumcutout locationfrom floor(Minimum 15-5/8"from floor wheninstalled below built-inmicrowave oven)EGF20Note: These ovens are not approved for stackable orside-by-side installations.Note: Cabinets installed adjacent to wall ovens must havean adhesion spec of at least a 194°F temperature rating.Note: For 27" built-in single ovens, if marks, blemishes orthe cutout opening is visible above the installed oven, itmay be necessary to add wood shims under the runnersand front trim until the marks or openings are covered.Note: Door handle protrudes 3" from door face. Cabinetsand drawers on adjacent 45° and 90° walls should beplaced to avoid interference with the handle.Electric wall ovens are not approved for installationwith a plug and receptacle. They must be hard wired inaccordance with installation instructions.Installation Information: Before installing, consultinstallation instructions packed with product for currentdimensional data.Cabinet 27"A – Cabinet width required 27" min.B – Minimum cabinet depth 23-5/8"C – Opening width 25" min. - 25-1/4" maxD – Opening height 27-5/8" min. - 28-1/8" max.OvenE – Overall depth* 23-5/8"F – Overall height with trim 29-7/8" - 30-3/4"Overall height without trim 29"G – Overall width 26-5/8"*Depth including door handle is approximately 26-7/10" min. to26-8/10" max.ccessomdjacentabinetquiredCLSuitablebracingto supportrunners 18"Over centerlineof cabinet(must support 275 lbs.)2" x 4" orequivalentrunners2" x 4"or equiv.runnersB MIN.C MIN.Conduit 48-1/2" long32-1/2D10A Allow 3/4"for overlapover all edgesof cutoutatetion boxer 5" MIN.w cutoutr or 44". aboveut floorimumut locationfloorimum 15-5/8"floor whenalled below built-inrowave oven)EGF20Dimensions and Installation Information (in inches)

/ 3

Related manuals for GE JKP70BM