GE JMS08 Owner's Manual

Also see for JMS08: Use and care guide Owner's manual Owner's manual Use and care guide Owner's manual

Contents

Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer SupportOven ShelvesClean the oven shelves with an abrasivecleanser or steel wool.After cleaning, rinse the shelves withclean water and dry with a clean cloth.Lift-Off Oven DoorThe oven door is removable for cleaning.Do not lift the door by the handle.To remove the door, open it to the broilstop position. Grasp firmly on each sideand lift the door straight up and off thehinges.Do not place hands between the hinge and theoven door frame.To replace the door, make sure the hingesare in the broil stop position. Position theslots in the bottom of the door squarelyover the hinges and slowly lower it overboth hinges.To clean the inside of the door: Soap and water will normally do thejob. Heavy spattering or spillovers mayrequire cleaning with a mild abrasivecleaner. Soapy, wet metal pads may alsobe used.Do not allow food spills with a high sugar or acidcontent (such as tomatoes, sauerkraut, fruit juicesor pie filling) to remain on the surface. They maycause a dull spot even after cleaning. If necessary, you may use an ovencleaner. Follow the package directions. Clean the inside of the oven windowwith a mild non-scratching cleaner anda damp cloth.To clean the outside of the door: Use soap and water to thoroughlyclean the top, sides and front of theoven door. Rinse well. You may alsouse a glass cleaner to clean the glasson the outside of the door. Do not letwater drip into the vent openings. Spillage of marinades, fruit juices,tomato sauces and basting materialscontaining acids may causediscoloration and should be wiped upimmediately. When surface is cool,clean and rinse. Do not use oven cleaners, cleaningpowders or harsh abrasives on theoutside of the door.Lift the door straight up and off thehinges.Oven Light ReplacementCAUTION: Before replacing your ovenlight bulb, disconnect the electricalpower to the range at the main fuse orcircuit breaker panel.Be sure to let the light cover and bulbcool completely.To remove the cover:Hold a hand under the cover so itdoesn’t fall when released. Withfingers of the same hand, firmlypush back the wire cover holder.Lift off the cover.Do not remove any screws to removethe cover.Replace bulb with a 40-watthousehold appliance bulb.To replace the cover:Place it into groove of the lightreceptacle. Pull wire forward to thecenter of the cover until it snapsinto place.Connect electrical power to therange.Wire cover holder.11ge.com