GE JN327, JV327 Use And Care Manual

Also see for JN327, JV327, JV337, JV347: Owner's manual and installation instructions Owner's manual and installation instructions Owner's manual and installation instructions Owner's manual and installation instructions Owners and installation manual

Contents

To OperateLamp Switch Models: JN327, JV327, JV337Press for OFF and ON.Lamp Switch Model: JV347Rotate clockwise, first position for NIGHT LIGHT,second position for BRIGHT LIGHT.Fan SwitchModels: JN327, JV327, JV337CENTER position OFF, DOWN position LOW SPEED,TOP position HIGH SPEED.Model: JV347Rotate Clockwise, FIRST position HIGH, SECONDposition MEDIUM, THIRD position LOW.Care and CleaningReplaceable Charcoal Filter—Used innon-ducted installations only.Models: JN327, JV347—non-ducted installations onlyThe charcoal filter cannot be cleaned. It must bereplaced.DO NOT RINSE OR PLACE THE CHARCOALFILTER IN A DISHWASHER.The efficiency of your hood depends upon a clean filter.The frequency of filter replacement depends on hooduse and the type of cooking you do. See replacementguidelines below for your non-ducted model installation.NEVER OPERATE THE HOOD WITHOUT THEFILTER IN PLACE.When to replace the filter:JN327 and JV347 (non-ducted installations only)—Thefilter should be replaced after 6 to 12 months. Order andreplace with genuine GE part: WB02X10700.To remove: Pull down on the center of the front edge ofthe filter. The filter will then slip out of the retaining tabson the back.To replace: Slip the back edge of the filter into the retainingtabs and push the front edge up until it snaps in place.Reusable Metal Grease Filter—Used inducted installations only.Models: JV327, JV337, JV347—ducted installations onlyThe efficiency of your hood depends on a clean filter.Frequency of cleaning depends on hood use and the typeof cooking you do. HOWEVER, THE GREASE FILTERSHOULD BE CLEANED AT LEAST ONCE A MONTH.NEVER OPERATE THE HOOD WITHOUT THEFILTER IN PLACE.To remove: Pull down on the center of the front edge ofthe filter. The filter will then slip out of the retaining tabson the back.To clean: Soak and then agitate it in a hot water anddetergent solution. Light brushing can be used to removeembedded dirt. Rinse, shake and let it dry before replacing.To replace: Slip the back edge of the filter into theretaining tabs and push the front edge up until it snapsinto place.With careful handling, the metal filter will last for years.If a new replacement becomes necessary, order the partfrom your dealer. Order genuine GE part: WB02X8391.HoodClean grease laden surfaces of the hood frequently.Use warm detergent solution. About 1 tablespoon ofammonia may be added to the water. TAKE CARE TONOT COME IN CONTACT WITH FILTERS ANDOTHER NON-ENAMELED SURFACES. The hoodshell can be washed, rinsed and dried with a soft cloth.Motor and FanTo Clean Motor and Fan1. DISCONNECT THE HOOD POWER SUPPLY ATTHE HOUSEHOLD DISTRIBUTION PANEL BYREMOVING THE FUSE OR SWITCHING OFFTHE CIRCUIT BREAKER.2. Remove the filter.3. Wipe the fan blade and motor with cloth, dampenedonly in ammonia and warm water solution.4. Replace the filter.5. Reconnect the hood power supply.CAUTION: Be certain when cleaning the hoodsurfaces you do not touch the lamp bulb with moisthands or cloth. A warm or hot lamp bulb may breakif touched with a moist surface. ALWAYS let lampcool COMPLETELY before cleaning around it.3Vents (JN327 & JV347)Fan switch Lamp switch