GE JP3030*J series Technical Service Manual

GE JP3030*J series Technical Service Manual Manual pdf 18 page image

– 18 – (Continued next page)Service Mode for Electronic Control CooktopService ModeService Mode can be entered by the following steps:1. Press and hold the front right burner ON/OFF key for 7 seconds until the tone is heard and "1" appears onthe timer.2. Press and hold the rear right burner ON/OFF key for 7 seconds until the tone is heard and the softwareversion appears on the timer.The following table provides the diagnostic features associated with each key.DIAGNOSTIC MODE SUMMARYKey ResponseLeft Rear +Displays fault codes on the Timer. Pressing this key multiple times will cyclethrough each fault code until dashes appear showing the end of the codes. If noactive faults exist, only dashes will be shown with each press.$OO2ȹ Pressing and holding for 5 seconds will clear the Fault Code that is currentlydisplayed.Left Front + Turns on all the LEDs for 5 seconds.Left Front - Exit Service Mode.Right Front - Display main board software version.Right Front + Display Induction board #1 software version.Right Rear - Display Induction board #2 software version.Right Rear + Display Induction board #3 software version (On 30 in. cooktop, this key is notvalid).Timer Select(or Timer ON/OFF)ONLY use this when a mistake has been made in setting the model number for aservice replacement board.To clear the service model number, press and hold for 7 seconds. Control will showSEt in timer block, ready to reprogram the service control's model number.