For answers to your Monogram,® GE Profile™ orGE® appliance questions, visit our website atge.com or call GE Answer Center ® service,800.626.2000.†Note: Check local codes for requiredbreaker sizeImportant: Requires a 5" free areabetween the bottom of the cooktop toany combustible material, i.e., shelving.Free area not required when installingwall oven underneath cooktop. Refer toinstallation instructions. Requires a15" minimum from cooktop to adjacentoverhead cabinets. Units are furnishedwith a 48" flexible armored cable.Note: 30" Ribbon cooktops are approved for use over select GE27"and GE 30" Single Wall Ovens and Warming Drawers. Refer tocooktop and wall oven/warming drawer installation instructionspacked with product for current dimensional data. If installedwith a GE Profile™ Telescopic Downdraft System, consult boththe cooktop and downdraft installation instructions packed withproduct before installing. Cooktop gas/electric supply may need tobe re-routed to install downdraft. Consult cabinetand countertop manufacturer’s specs for flush mount installationpriorto install. Before installing, consult installation instructionspacked with product for current dimensional data.KW Rating240V 7.6208V 5.7Breaker Size240V 40 Amps†208V 30 Amps†3-1/4*Cooktop2-1/2**Required28-1/219-5/829-7/830_ss_cktp_install.eps21-1/2Electrical junction box 16" MIN.below countertop30" MIN. tounprotectedcabinetCut shouldnot interferewith cabinetstructureat front1-1/2" MIN.clearance toside wallfrom cut-out1-1/2" MIN.clearance toside wallfrom cut-out1-3/4" torear wall13" MAX.depth* Depth of unit at conduit connection location (rear) is6-1/2" on models PP980/950 and 4-5/8" on modelsPHP900/PP975/972/962/945/942/932/912,JP655/356/346.**Raised bull nose countertops may require up to3/8" additional clearance to prevent interferencewith curved front.15" MIN.to cabinetListed byUnderwritersLaboratoriesDimensions and Installation Information (in inches)321360Specification Revised 12/07JP356SMGE® 30" Built-In CleanDesign Electric Cooktop