GE JS968SFSS Installation Instructions Manual

Also see for JSP47: Owner's manual Owner's manual Owner's manual Owner's manual Installation instructions

Contents

GE JS968SFSS Installation Instructions Manual Manual pdf 11 page image

11Installation InstructionsInstalling the RangeFIG. 1Decide whether the bracket will beinstalled on the right or left side of therange opening.Place the bracket as shown in Fig. 1.FIG. 2INSTALLING THE BRACKETIN WOOD OR CONCRETE10INSTALLATION—WOODCONSTRUCTIONSLocate the centers of the 4 holesidentified in Fig. 1 as Floor–Wood andWall.Drill a 1/8” pilot hole through thepre-marked areas. Note the angle ofthe wall screw in Fig. 2.Mount the Anti-Tip bracket with the4 screws provided.INSTALLATION—CONCRETECONSTRUCTIONSFor concrete installation, you will needtwo 1/4” x 1-1/2” lag screws and twosleeve anchors.Locate the center of the 4 holesidentified in Fig. 1 as Floor–Concreteand Wall. Drill the recommended sizeholes in each.Install the sleeve anchors into thepredrilled concrete holes and install thelag and wall screws through the Anti-Tipbracket. Make sure the screws aresecurely tightened.To Front Edgeof CountertopBracketWall PlateScrew MustEnter Woodor Metal25”REPLACE THE WIRE COVER8Replace the wire cover(on the back of therange) by replacing the2 screws removedearlier. WireCoverNOTE: When reinstalling the wirecover, make sure that wires do notbecome pinched between the wirecover and the housing.LOCATING THE ANTI-TIP BRACKET9ABAdjacentCabinetBracketSideFLOOR–WOODRearLeveling Leg FLOOR–CONCRETEWallWARNING:Range must be secured by Anti-Tipbracket supplied.See instructions to install (suppliedwith bracket).Unless properly installed, the rangecould be tipped by stepping or sitting onthe door. Injury may result from spilledhot liquids or from the range itself.ABCABC(Continued on following page)